Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: Mike F250
Showing results 1 to 15 of 498
Search took 0.56 seconds.
08-13-2018, 11:55 PM
Replies: 13
Views: 753
Posted By Mike F250

Did you happen to find a solution? I've still...

Did you happen to find a solution? I've still just been living with it. I rarely drive after dark so it's not a big issue. I just hate seeing that door ajar light on.
03-12-2018, 08:45 AM
Replies: 13
Views: 753
Posted By Mike F250

Thanks. I appreciate any help. When I swapped...

Thanks. I appreciate any help.
When I swapped the doors, I gutted the wiring. Pulling the 2008 harness out and guiding the original 2001 wiring back in. The original wiring was never detached from...
03-10-2018, 05:12 PM
Replies: 13
Views: 753
Posted By Mike F250

Hey, me again. I've just been ignoring the light...

Hey, me again. I've just been ignoring the light for a while. Today I opened the door back up because it really bugs me.

WD40 didn't work.

I've used AE to determine the drivers side rear is the...
10-16-2017, 08:37 AM
Replies: 13
Views: 753
Posted By Mike F250

My trouble is with the drivers side rear door. ...

My trouble is with the drivers side rear door.
I purchased a new door switch from Ford because I could not get the old switch to read anything. I tried ohms, continuity and voltage (while plugged...
10-09-2017, 09:48 AM
Replies: 13
Views: 753
Posted By Mike F250

So, AE does allow for each door to be read. From...

So, AE does allow for each door to be read. From the GEM option when connecting the truck. Live data meter will show each individually.

So, the WD-40 trick didn't work for me. Any other...
10-02-2017, 08:55 AM
Replies: 13
Views: 753
Posted By Mike F250

Thank you! I have AE. I'll see if I can figure...

Thank you! I have AE. I'll see if I can figure out how to access this
10-01-2017, 09:01 PM
Replies: 13
Views: 753
Posted By Mike F250

new doors and door ajar light

So, I've searched through many spray and go away posts on the issue.
I'd rather not spray each door and open/close 20 times.
Is there a way to determine the offending sensor?

Background: I just...
09-11-2017, 09:52 AM
Replies: 21
Views: 1,813
Posted By Mike F250

so, I'm new to this section as I'm doing my...

so, I'm new to this section as I'm doing my research on the gooseneck setup.
Opinions on this?
...
03-26-2017, 10:48 AM
Replies: 7
Views: 338
Posted By Mike F250

Williamston, MI area for me. GR is about an hour...

Williamston, MI area for me. GR is about an hour away. Inlaws in Grand Haven. So I do a drive by GR a few times a year.

Joe, where are you at in MN? I grew up in St. Augusta/St. Cloud area. All my...
12-12-2016, 07:42 AM
Replies: 4
Views: 358
Posted By Mike F250

Thanks for the replies! I'll check into it ASAP. ...

Thanks for the replies! I'll check into it ASAP.
The directions to the EX folder is a gold mine.

Reminds me I still need to go through the failure prevention thread...
12-07-2016, 02:21 PM
Replies: 4
Views: 358
Posted By Mike F250

OD light came on. Shut of caused fuse to blow

Hi all, A rather unique scenario.
I jumped on the brakes on a dirt road and the antilock cycled. I then noticed the OD off light was on. NP, I push the button.
Immediately blew fuse 19. So, no...
09-28-2015, 11:10 AM
Replies: 20
Views: 1,196
Posted By Mike F250

If the pics load, here's what I did to the bikini...

If the pics load, here's what I did to the bikini hook.
I don't like the angle because I have to lean over to see the number on the tuner. I now have an ash tray that I plan to modify to hide the...
04-24-2015, 05:08 PM
Replies: 12
Views: 3,874
Posted By Mike F250

Old thread. But, the most recent in my search. I...

Old thread. But, the most recent in my search. I have a rust free bed upside down on my trailer right now. I'm researching what to apply to the underside to keep it rust free as long as possible....
01-04-2015, 12:09 PM
Replies: 5
Views: 538
Posted By Mike F250

just to follow up in case others run into this...

just to follow up in case others run into this same issue...
The trans cooler lines run over the cross member and rub against the power wire to the starter. The starter wire has a woven sheath to...
01-01-2015, 12:21 PM
Replies: 5
Views: 538
Posted By Mike F250

Funny, I never look forward to the trip but, I...

Funny, I never look forward to the trip but, I always have a good time while here.

Thanks to all for the replies. And, Happy New Year!

I'll do the patch for now and put in new lines when I get...
Showing results 1 to 15 of 498
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.