Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: BRay09
Showing results 1 to 15 of 500
Search took 0.37 seconds.
Replies: 63
Views: 17,870
Posted By BRay09

you do realize that the thread is 9 years old,...

you do realize that the thread is 9 years old, correct?

that being said, you will need to swap to flat tappet lifters, push rods, remove the dog bones and change your distributor gear to a cast...
01-08-2019, 09:05 AM
Replies: 9
Views: 413
Posted By BRay09

Only reason being that I want to put a new oil...

Only reason being that I want to put a new oil cooler in is due to the screen underneath it. I would like to put in new injectors in it and that's a common failure item. Im not sure if it's ever been...
01-07-2019, 04:29 PM
Replies: 9
Views: 413
Posted By BRay09

Should probably get new boots and do a CCV...

Should probably get new boots and do a CCV reroute as I have not done this yet. Turbo has a reman sticker on it with no shaft play and no oil seen on the cold side impeller. Hard to say when it was...
01-07-2019, 04:26 PM
Replies: 9
Views: 413
Posted By BRay09

deltas are 10* apart at 296k miles. If I'm...

deltas are 10* apart at 296k miles. If I'm digging this far in, may as well throw in an OEM cooler. Might do an egr delete or bullet proofed cooler. Have not decided.

the truck runs like crap...
01-07-2019, 04:22 PM
Replies: 9
Views: 413
Posted By BRay09

indeed it is running from the valley down tha...

indeed it is running from the valley down tha back of the engine. That's not saying the oil pan gasket isnt leaking or anything. I just need to fix up top first and go from there
01-04-2019, 11:52 AM
Replies: 9
Views: 413
Posted By BRay09

Oil leak in valley

Hi all,

It's been awhile since I've posted. I have an 04 6.0L with 300k on the clock. I have a fairly good oil leak that leaves around an 8in puddle of oil under the truck when it sits over night....
10-23-2018, 12:01 PM
Replies: 2
Views: 276
Posted By BRay09

this module would not allow the pump to run. The...

this module would not allow the pump to run. The pump runs and I am getting pressure to the rail, but the injectors aren't spraying fuel into the intake.
10-22-2018, 01:44 PM
Replies: 2
Views: 276
Posted By BRay09

2000 f250 5.4L crank no start

Hello all,

2000 f250 5.4 will crank, but not start. I have spark and ~40# to the rail, but no injector pulse. Will run on starting fluid. Removed GEM and PCM to check for corrosion. Have found...
09-27-2018, 02:22 PM
Replies: 12
Views: 559
Posted By BRay09

Just a quick update. I changed the oil and threw...

Just a quick update. I changed the oil and threw in hot shots stictation eliminator. Stuff works well in the 6.0s so I figured, why not. Well fired then truck up and it was still loping at idle....
09-20-2018, 06:45 PM
Replies: 1
Views: 187
Posted By BRay09

04 4wd 3.0 engine mounts

04 4wd 3.0 engine mounts

are these things non existent? Everywhere I look, I find a front left mount, but one is not listed for the front right. Are they the same mount? Will one's from a RWD be...
09-06-2018, 03:33 PM
Replies: 11
Views: 393
Posted By BRay09

https://cimg1.ibsrv.net/gimg/www.ford-trucks.com-v...

https://cimg1.ibsrv.net/gimg/www.ford-trucks.com-vbulletin/400x400/118242_tow_ready_oe_tow_package_wiring_harness_2a60411ff97742caa71d7ceb71e801a68719e655.jpg
TooManyToys I used a couple p/n off...
09-06-2018, 03:21 PM
Replies: 11
Views: 393
Posted By BRay09

I recieved the p/n 2c3z-13a576-da from the...

I recieved the p/n 2c3z-13a576-da from the dealer. Unfortunately, I need the plug on the truck side of the trailer plug harness. The square plugs corroded and broke pins off inside the connectors, so...
09-06-2018, 12:31 PM
Replies: 11
Views: 393
Posted By BRay09

will do. Just got off the phone with the...

will do. Just got off the phone with the receptionist and let her know what I was looking for and they will be working on it and call me back. I will update when I receive a call.
09-06-2018, 08:14 AM
Replies: 11
Views: 393
Posted By BRay09

I went to the dealer and he gave me the p/n of...

I went to the dealer and he gave me the p/n of the trailer 7/4pin assembly and harness, but not the one on the truck side. I will speak with ed if I cannot find a donor truck around me to steal the...
09-05-2018, 08:25 PM
Replies: 12
Views: 559
Posted By BRay09

everything on the truck is stock except for the...

everything on the truck is stock except for the IDM from swamps that was installed when I bought the truck.
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.