Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: 52 F3
Showing results 1 to 15 of 499
Search took 4.77 seconds.
08-13-2011, 08:07 AM
Replies: 12
Views: 470
Posted By 52 F3

Is the top rear line attached to the case with a...

Is the top rear line attached to the case with a clip and both ends not attached.
It may be the hard line that comes down from the engine and connects to the vac modulator.
08-12-2011, 06:01 PM
Replies: 12
Views: 470
Posted By 52 F3

The top rear one may be a vent pipe. The two...

The top rear one may be a vent pipe.
The two cooler lines should be flared lines screwed into fittings in the case.

Edit

The vent is not at the rear of the trans. it is above the front...
08-12-2011, 01:43 PM
Replies: 12
Views: 470
Posted By 52 F3

If you don't run a cooler of some type you WILL...

If you don't run a cooler of some type you WILL cook the trans in very short order.

The cooler is not optional under any circumstances. It is necesssary.
08-08-2011, 04:10 PM
Replies: 8
Views: 1,037
Posted By 52 F3

Take a close look at them and see if they are...

Take a close look at them and see if they are made up.
Is the bullet glued into the center of another lens?
08-08-2011, 03:59 PM
Replies: 5
Views: 623
Posted By 52 F3

What you are hearing has nothing to do with the...

What you are hearing has nothing to do with the valves.
If high octane gas eliminates the problem it is most likely detonation.
08-07-2011, 09:01 AM
Replies: 6
Views: 465
Posted By 52 F3

I have always heard them called service truck and...

I have always heard them called service truck and utility bed.
I don't know if they had an official name.
I'm sure diffferent manufacturers had different names for the beds.
They were used for a...
08-07-2011, 08:54 AM
Replies: 10
Views: 1,328
Posted By 52 F3

Sounds like the cab is tweaked. If the back of...

Sounds like the cab is tweaked.
If the back of the door is low the front gap should be larger at the top.

What conditon are the cab mounts in?
It could be the cab mounts letting the cab settle....
08-05-2011, 08:24 AM
Replies: 5
Views: 623
Posted By 52 F3

Not sure I understand the question but at least...

Not sure I understand the question but at least this will bump this back up.

Is there a reason not to use the rockers, springs, valves and push rods that are original to with the heads?
08-02-2011, 12:19 PM
Replies: 9
Views: 3,567
Posted By 52 F3

The shafts and bushings may well be worn but they...

The shafts and bushings may well be worn but they are not the cause of the gas leaking out around them.
The carb must be flooding over enough to dump gas down the throats enough to run out at the...
07-29-2011, 07:42 PM
Replies: 6
Views: 674
Posted By 52 F3

If the alt and regulator are known good and the...

If the alt and regulator are known good and the wireing is right it will work.
Time to go back over things and see what isn't right.
Can you post a drawing of how it is wired and let us know what...
07-26-2011, 09:39 PM
Replies: 21
Views: 4,750
Posted By 52 F3

If you got it fixed that's great. If any of us...

If you got it fixed that's great.
If any of us were of any help you are welcome.
Whether you share the results or not is pretty much up to you.
07-26-2011, 01:38 PM
Replies: 225
Views: 12,332
Posted By 52 F3

Age 63 1930 AA 1952 F-3 1959 F-100

Age 63

1930 AA
1952 F-3
1959 F-100
07-25-2011, 01:22 PM
Replies: 15
Views: 1,224
Posted By 52 F3

Just FYI. I believe the 80's F-100's did not...

Just FYI.
I believe the 80's F-100's did not have the same wheel bolt pattern as the F-150's.
It was a smaller pattern that I believe was the same as the Explorers.
That might be either good or...
07-25-2011, 10:06 AM
Replies: 33
Views: 1,330
Posted By 52 F3

What's the chance you put the spindle on upside...

What's the chance you put the spindle on upside down?
07-24-2011, 09:47 PM
Replies: 15
Views: 1,224
Posted By 52 F3

I knew they put those in the T'Birds, LTD's,...

I knew they put those in the T'Birds, LTD's, maybe mustangs for a couple of years but never knew they put them in the F-100's.
I think they have a light weight crank in them that some search out for...
Showing results 1 to 15 of 499
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.