Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: 76supercab2
Showing results 1 to 15 of 483
Search took 0.85 seconds.
12-20-2011, 02:20 PM
Replies: 3
Views: 344
Posted By 76supercab2

What year truck? The hydraulic master...

What year truck?

The hydraulic master cylinder is very difficut (approaching impossible) to bleed on the truck. Before I pulled the transmission, I would pull the clutch MC and bench bleed it.
...
10-21-2011, 06:47 AM
Replies: 28
Views: 1,367
Posted By 76supercab2

What a sad thing to do to the Bel Air.

What a sad thing to do to the Bel Air.
10-21-2011, 06:46 AM
Replies: 28
Views: 1,367
Posted By 76supercab2

That's fine. But if you look at the list, I've...

That's fine. But if you look at the list, I've included the Crown Vic. Both the CV and the Torino are full sized, 2wd cars. There was a 4 door model of the Torino. The Vic is approx 100 lbs...
10-19-2011, 11:35 PM
Replies: 28
Views: 1,367
Posted By 76supercab2

1972 Ford Torino curb weight: 3,3694,042 lb ...

1972 Ford Torino curb weight: 3,3694,042 lb

2010 F-350 curb weight: 6698 lb
2010 F-150 XL Supercrew: Gross weight: 6800 lbs. Curb weight: 5156 lbs.
2002 Sable Curb weight: 3643 lb (FWD)...
10-18-2011, 09:05 AM
Replies: 2
Views: 7,040
Posted By 76supercab2

Probably not. I pulled one off a '93. I'd guess...

Probably not. I pulled one off a '93. I'd guess it weighed between 150 and 200 lbs. It was unweildy enough that my son and I couldn't handle it. 1 more guy and we lifted it off no problem. If...
10-11-2011, 06:17 PM
Replies: 14
Views: 773
Posted By 76supercab2

I can get 25-26mpg out of my 3.0. :confused:

I can get 25-26mpg out of my 3.0. :confused:
10-10-2011, 11:29 PM
Replies: 12
Views: 600
Posted By 76supercab2

Use Eye Protection!!!!! Also, if you...

Use Eye Protection!!!!!


Also, if you aren't going to replace the metal, then at least check out POR15 from Restomotive Labs. Good stuff and it does work.
10-10-2011, 09:46 AM
Replies: 9
Views: 590
Posted By 76supercab2

Why not buy a used one, rebuild it, then install...

Why not buy a used one, rebuild it, then install it in your truck?
10-03-2011, 09:29 AM
Replies: 5
ABS
Views: 713
Posted By 76supercab2

First of all, the Ford Ranger RABS system does...

First of all, the Ford Ranger RABS system does not have a pump. It has a valve module which has 2 valves in it to perform the following functions:
1. Block the hydraulic line from the master...
09-28-2011, 11:21 AM
Replies: 6
Views: 531
Posted By 76supercab2

93Ranger, If you're servicing the trans, the...

93Ranger, If you're servicing the trans, the repair in the video is a good one to do while you have it out. The kit cost me less than $20 and it's as easy to do as the video shows.

Also, if your...
09-28-2011, 08:15 AM
Replies: 6
Views: 531
Posted By 76supercab2

IIRC, when I did it, I removed the nut from one...

IIRC, when I did it, I removed the nut from one side and threaded it onto the other side. As I tightened the nut, it pulled the shaft out of the shifter handle.
09-27-2011, 11:25 AM
Replies: 11
Views: 13,366
Posted By 76supercab2

It would not be a bad idea. I personally know...

It would not be a bad idea. I personally know two people who have had brake lines fail due to rust.

Also, it's a good idea to flush your brake system every 1 or 2 years and keep fresh clean fluid...
09-26-2011, 09:31 AM
Replies: 9
Views: 8,838
Posted By 76supercab2

That is an understatement. By catching it and...

That is an understatement. By catching it and replacing it, you saved yourself the cost of a new motor. When the synchronizer bearings go and the cam sensor starts squeaking, it can seize and stop...
09-26-2011, 09:19 AM
Replies: 3
Views: 6,263
Posted By 76supercab2

As stated before, unless you have modified the...

As stated before, unless you have modified the system, your truck does not have an oil pressure guage. It has an indicator light disguised as an oil pressure guage. The sender is an on/off switch...
09-21-2011, 08:59 PM
Replies: 5
Views: 4,274
Posted By 76supercab2

Sorry for delay. From the 1993 Ford...

Sorry for delay.


From the 1993 Ford Service Manual:
The Tach has 4 connections labeled on the instrument cluster PCB as:
1. SIG (EDIS Tach Signal In)
2. IGN (Power from Ignition Switch)...
Showing results 1 to 15 of 483
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.