Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: F SUPER DUTY
Showing results 1 to 15 of 25
Search took 0.27 seconds.
03-25-2015, 08:06 AM
Replies: 2
Views: 448
Posted By F SUPER DUTY

Coils and Rotors

Two questions. 2004 F150 New body style 5.4 2wd. What name brand ignition coils have good reliability performance? I need to replace the front brake rotors.These are the one piece pressed in bearing...
03-13-2014, 10:23 PM
Replies: 2
Views: 842
Posted By F SUPER DUTY

Got the front tore down. Wheel bearing has a bad...

Got the front tore down. Wheel bearing has a bad seal. They feel tight. 100k miles approximate on truck. I plan on replaceing both sides. Timken replacement hub and bearing about $180. each. Would...
03-13-2014, 09:57 PM
Replies: 15
Views: 1,312
Posted By F SUPER DUTY

Has anyone used Raybestos brand Calipers? Any...

Has anyone used Raybestos brand Calipers? Any preffered brands?I need to replace one of the originals and will probably do both sides. FSD
03-12-2014, 10:23 PM
Replies: 2
Views: 842
Posted By F SUPER DUTY

F450 Unit bearing Questions

How many miles are you guys getting from the front wheel unit bearings before replaceing them? Those who have replaced them. What name brand do you think are the best replacements? 99-2002 F450...
03-04-2014, 09:16 PM
Replies: 6
Views: 1,729
Posted By F SUPER DUTY

Thanks for the replies. I plan on doing this...

Thanks for the replies. I plan on doing this myself. The truck has a lot of negative camber. Just replaced the ball joints. So i will need to figure which Alignment bushings to buy. Thanks again FSD
03-04-2014, 10:57 AM
Replies: 6
Views: 1,729
Posted By F SUPER DUTY

The F450 is different from a F350 This truck is...

The F450 is different from a F350 This truck is a 99 2 wheel drive with a leaf spring straight axle up front. Thanks. FSD
03-04-2014, 07:03 AM
Replies: 6
Views: 1,729
Posted By F SUPER DUTY

99 F450 alignment

I need the wheel alignment specs 99 F450 solid front axle 2wd.I did a search and came up empty. Any help is appreciated. Thanks FSD
01-14-2013, 11:10 PM
Replies: 0
Views: 321
Posted By F SUPER DUTY

DANA 80 questions.

Is the Dana 80 housing and spindle size the same from 93-99? Any info is appreciated. I am not familiar with 99 and up F450 axles. Thanks, FSD
04-05-2012, 06:52 PM
Replies: 0
Views: 391
Posted By F SUPER DUTY

88 E 350 RV No fuel

88 RV chassis Fuel injected 460 single tank. Turn key on no fuel pump noise.Engine will pop off on starting fluid. Where is the inertia switch located? Does this have a pump in the tank and a...
02-14-2012, 01:05 PM
Replies: 8
Views: 683
Posted By F SUPER DUTY

I had decided on poly, but they are not available...

I had decided on poly, but they are not available for my truck. Rear leaf spring bushings 93 F450/Super Duty. Energy suspension has a front spring kit. Nothing for the rear. Looked on the Fab Build...
02-12-2012, 01:54 PM
Replies: 92
Views: 20,594
Posted By F SUPER DUTY

How many miles were on those trans splines. May...

How many miles were on those trans splines. May be informative for someone looking to buy a comparable truck. Definetly a solid resto. Sand blast and POR 15. No future rust issues there. FSD
02-10-2012, 01:44 PM
Replies: 8
Views: 683
Posted By F SUPER DUTY

Bushings

I am replacing the leaf spring bushings in my rear springs. Should i go with rubber or poly? I replaced the front leaf spring bushings with poly about six years ago and they are holding up just fine....
02-08-2012, 03:58 PM
Replies: 9
Views: 12,151
Posted By F SUPER DUTY

Bed looks good. Will you put small gussets from...

Bed looks good. Will you put small gussets from your cross channels to the dump main frame? The rub rail is a good idea. You can never have to many locations to hook a strap or chain. FSD
02-08-2012, 08:15 AM
Replies: 6
Views: 1,877
Posted By F SUPER DUTY

FPDM was bad. The dealer sells a replacement that...

FPDM was bad. The dealer sells a replacement that is the same design or a newer design that should not have the same issue. As stated above a very common problem i did not know exsisted. Thanks, for...
01-31-2012, 05:34 PM
Replies: 8
Views: 2,625
Posted By F SUPER DUTY

I would agree with fixing/repairing what you have...

I would agree with fixing/repairing what you have instead of a used replacement. Just bought a "change fluid and run it" rear end that unexpectedly needs about $300 in parts. So with time and two...
Showing results 1 to 15 of 25
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.