Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: jimjokjv
Showing results 1 to 15 of 455
Search took 0.08 seconds.
02-16-2019, 08:13 PM
Replies: 7
Views: 140
Posted By jimjokjv

I would check all the ground wires too. Since...

I would check all the ground wires too. Since you are certain you have enough power the grounds are most likely the problem. Is the starter in tight and well grounded to the block? Are the...
01-29-2019, 09:07 PM
Replies: 9
Views: 233
Posted By jimjokjv

Yes, I just need to pull it and send it. Just...

Yes, I just need to pull it and send it. Just haven't taken the time to do it yet.
01-29-2019, 09:05 PM
Replies: 9
Views: 233
Posted By jimjokjv

GPCM which is the second new one I put in just to...

GPCM which is the second new one I put in just to be sure that wasn't the problem.
01-29-2019, 06:00 PM
Replies: 9
Views: 233
Posted By jimjokjv

Thanks for the above information. I will copy...

Thanks for the above information. I will copy that into my PCM folder for future reference.

There are no labels at all on the PCM unit itself and it obviously has been painted at some point.
...
01-29-2019, 10:45 AM
Replies: 9
Views: 233
Posted By jimjokjv

PCM Numbers

Using Forscan I got the following information about my PCM:

PCM - Powertrain Control Module
Part number: XU7FCC
Strategy : VNABLNB DPC-452
Copyright Ford Motor Co. 2010

Notice the Part...
01-25-2019, 12:58 PM
Replies: 13
Views: 490
Posted By jimjokjv

I do not want to hijack this thread but have a...

I do not want to hijack this thread but have a question. What if my PCM numbers don't match anything on your list?
01-21-2019, 07:18 PM
Replies: 4
Views: 213
Posted By jimjokjv

How fast is it cranking over? If not real crisp...

How fast is it cranking over? If not real crisp and quick then you should remove the cables and fully charge each battery. Clean and reconnect and see if it fires. Mine wouldn't start but would...
01-21-2019, 09:57 AM
Replies: 60
Views: 2,822
Posted By jimjokjv

If it was a poppet clearance problem, you would...

If it was a poppet clearance problem, you would have definitely heard the difference in the buzz test unless they were all bad.

I agree on the batteries and starter. Replaced my starter a couple...
01-13-2019, 04:14 PM
Replies: 6
Views: 311
Posted By jimjokjv

Sounds like your sending unit has a bad spot. ...

Sounds like your sending unit has a bad spot. Problem I found is the sending units for these trucks are outrageously priced.
01-12-2019, 09:16 AM
Replies: 6
Views: 311
Posted By jimjokjv

I had the same issue. Did the mods on the tank,...

I had the same issue. Did the mods on the tank, checked the float and sending unit and it still would stick in spots.
I found it to be connected to my ignition switch. If I turned the switch on and...
01-10-2019, 05:03 PM
Replies: 5
Views: 256
Posted By jimjokjv

Check your ground connections. There is one...

Check your ground connections.
There is one under the kick panel by your feet. At least there is on my 2000.
01-07-2019, 09:39 AM
Replies: 54
Views: 1,644
Posted By jimjokjv

Not sure if this will help your situation or not...

Not sure if this will help your situation or not but I had some electrical gremlins that were intermittent. Found them connected to turning the key on and off. Ended up replacing the plastic switch...
01-06-2019, 04:14 PM
Replies: 54
Views: 1,644
Posted By jimjokjv

Wasn't trying to hijack the thread, just keep it...

Wasn't trying to hijack the thread, just keep it going on the same topic.
Figured the OP would jump in again if needed.
01-05-2019, 07:19 PM
Replies: 54
Views: 1,644
Posted By jimjokjv

Hmmm, I use a battery tender on my Harley and...

Hmmm, I use a battery tender on my Harley and Quad but never thought about the truck because of the two batteries. This thing will handle that no problem. Thanks for the heads up!
01-05-2019, 04:43 PM
Replies: 54
Views: 1,644
Posted By jimjokjv

That's what I am thinking as well. One thing I...

That's what I am thinking as well.
One thing I did notice though was that even when the truck was running well prior to the new batteries my voltage tests were only 12.4 to 12.7 after glow plugs...
Showing results 1 to 15 of 455
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.