Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: f 250 mike
Showing results 1 to 15 of 24
Search took 0.42 seconds.
Replies: 1
Views: 321
Posted By f 250 mike

1980 f250 gear ratio ?

I need to know what my gear ratio is with my transfer case in 4 low.
The truck has a C6 transmission, 208 transfer case,3.54 gears, and 35" tires.
What ratio do I have at the wheel in first,...
Replies: 13
Views: 366
Posted By f 250 mike

intake manifold wars

I use the Stealth on my 473ci mudracer and have no compaints. It lets the motor wind up to 6000rpm's where rev limiter is set and has real good bottom end torque.
No experiance with the edelbrock...
Replies: 10
Views: 304
Posted By f 250 mike

Can anybody recomend a good hi-po mechanical fuel pump?

I have a friend that uses stock mechanical pump.I think it was made for an early fe with dual carbs. He runs a modified 428cj in his 4x4 race truck.
This 428cj runs at around 6500-6800rpms and has...
Replies: 15
Views: 22,861
Posted By f 250 mike

Does anyone know about D8VE-A2A heads

Hey guys,
Thanks for sticking up for me.
I looked at these heads at least three times before I decided my eyes weren't playing tricks on me.
They are D8VE-A2A .
Sure would like to know more...
Replies: 15
Views: 22,861
Posted By f 250 mike

Does anyone know about D8VE-A2A heads

These heads are on a 460 but may be off of a 429 truck engine.
They don't have the holes in the end for the crossover tube just a bump where it is suppose to be.
I was told these heads were cast...
Replies: 4
Views: 544
Posted By f 250 mike

Anyone have a link to a site with a BBF intake shootout?

Sorry
They didn't list any #s only the best to worst for torque and the best to worst for hp.
At the bottom of the page they listed the stealth as best overall.
They said no #s were listed so...
Replies: 3
Views: 462
Posted By f 250 mike

Replies: 4
Views: 544
Posted By f 250 mike

Anyone have a link to a site with a BBF intake shootout?

The site you are looking for is no longer available.
I believe that the weiand stealth was #3 in torque and #4 in hp.
The stealth had the best all around average of all intakes they dyno tested....
Replies: 6
Views: 1,291
Posted By f 250 mike

What oil should I use in my 460 mud truck ??

Thanks for your reply I think 10w30 will be my oil of choice and might go with synthetic in the future.

f250mike
Replies: 6
Views: 1,291
Posted By f 250 mike

What oil should I use in my 460 mud truck ??

This 460 is in my f250 4x4 and is used primarily for mudracing at approx. 6000 rpm max..
Castrol 10w30 is what I used until my last oil change which is only the 460s 3rd oil change.
I switched to...
06-26-2001, 12:20 AM
Replies: 4
Views: 221
Posted By f 250 mike

New update on my 460 project

Since the break in period we have run the truck in three mud drag events.
So far we haven't had any broken parts, but with the power this 460 has I don't know if the drive train will hold up all...
05-19-2001, 02:53 PM
Replies: 4
Views: 311
Posted By f 250 mike

my 460 buildup update

If you would like to see what I have done to my engine look for my March 13 ? that was posted on this board.
I did vary the rpm when it was broke in, from idle to 3000rpm never holding at one rpm...
Showing results 1 to 15 of 24
 


 
Forum Jump

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.