Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: big job
Showing results 1 to 15 of 500
Search took 1.18 seconds.
09-12-2018, 05:34 AM
Replies: 5
Views: 331
Posted By big job

Let me try this. ? Nope that didn't work. Pure...

Let me try this. ? Nope that didn't work. Pure case of "it ain't broke but somebodys goning to fix it"
09-10-2018, 02:38 AM
Replies: 5
Views: 409
Posted By big job

guess you need a small 3 corner file lots a...

guess you need a small 3 corner file lots a patients . It is right hand thread and being fine thread they are
kind a bitchy....
09-10-2018, 02:34 AM
Replies: 25
Views: 1,056
Posted By big job

I have no answer = my question of the Century is,...

I have no answer = my question of the Century is, How in hell did they get into my pressure plate. Yes there is
a clutch cover with only a 1/8 drain hole?? 1956 T800 I discovered this cause of...
Forum: Large Truck
09-06-2018, 06:29 AM
Replies: 10
Views: 1,787
Posted By big job

Check out International and Dodge forums they...

Check out International and Dodge forums they used lots of Clarks...Then I will mention shifting without a clutch anyone who drives late Autocars & Pete's no clutch needed. If one grew up with crunch...
09-06-2018, 04:01 AM
Replies: 9
Views: 463
Posted By big job

Frankly its just a bitch. remove passenger seat...

Frankly its just a bitch. remove passenger seat thats the only way (with cherry picker) ...........
09-06-2018, 03:55 AM
Replies: 7
Views: 309
Posted By big job

Me too and I have points, that way no need for...

Me too and I have points, that way no need for AAA towing...........
09-06-2018, 02:59 AM
Replies: 8
Views: 395
Posted By big job

From the pics thats a 5 sp direct. so you would...

From the pics thats a 5 sp direct. so you would pump in 5th if overdrive you would pump in 4th. For now if me
flush the case with diesel best you can and fill with 140# gear oil bottle of STP may...
09-05-2018, 07:52 AM
Replies: 14
Views: 517
Posted By big job

Good ole band saw. There should be tell tale...

Good ole band saw. There should be tell tale marks on the metal shoes as to how long to shorten not much maybe an inch or so.......
09-05-2018, 12:57 AM
Replies: 8
Views: 395
Posted By big job

https://cimg2.ibsrv.net/gimg/www.ford-trucks.com-v...

https://cimg2.ibsrv.net/gimg/www.ford-trucks.com-vbulletin/2000x1124/337_cid_987f777e1e2d360b4613b22b099fab57f6874dda.jpg

Here ya goe 9700 mile 337
Thats what was done in the mid 1950s. The...
08-25-2018, 07:14 AM
Replies: 0
Views: 161
Posted By big job

Power steering control valve

Just wondering if anyone has a control valve in their stash pile for any Big Job goes on the drag link. I have
everything else >> 1953 F900. OR Air 0 Matic they work fine... sam
08-25-2018, 07:08 AM
Replies: 2
Views: 273
Posted By big job

hood question ?

I figure I'd ask for someone that maybe use gas struts. Been living with no hood springs for 30yrs and use
a prop stick. Problem is the older I get I need young blood to lift it . I know hinges...
Forum: Large Truck
08-07-2018, 04:10 AM
Replies: 2
Views: 428
Posted By big job

Are you looking for a replacement? Probably...

Are you looking for a replacement? Probably better off looking for a 332 used into the early 1960s should think
there are more around than a 317.. sam
08-03-2018, 02:04 AM
Replies: 40
Views: 2,127
Posted By big job

I looked at mine and the door jam tag is the same...

I looked at mine and the door jam tag is the same as all other 56 models. Just buy one for a F100. The COE
comes into play with numbers and letter stamping.
Forum: Large Truck
08-01-2018, 03:49 AM
Replies: 4
Views: 406
Posted By big job

Need to know the make of the PTO is it cable or...

Need to know the make of the PTO is it cable or air operated. Pretty simple a sliding gear slides & meshes with the trans counter shaft. If the PTO drive shaft is turning then its a pump problem....
07-25-2018, 07:40 AM
Replies: 16
Views: 1,281
Posted By big job

Myself I would remove the push rod and manually...

Myself I would remove the push rod and manually move the lifter up and down with a magnet to see if its sticky
Also does it have valve stem caps? .sounds like the lifter is not bottoming out on the...
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.