Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: Krewat
Showing results 1 to 15 of 342
Search took 0.73 seconds.
Replies: 7
Views: 230
Posted By Krewat

I will say, I ran my highboy's 390 at 11:1...

I will say, I ran my highboy's 390 at 11:1 compression, with an Edelbrock Performer 390 with no exhaust crossover, and even in the dead of winter, it would be just fine. I did, however, run a Holley...
Yesterday, 07:29 AM
Replies: 2
Views: 104
Posted By Krewat

Nice find! :-X22

Nice find! :-X22
Yesterday, 07:28 AM
Replies: 2
Views: 143
Posted By Krewat

Get a fuel pressure gauge on it and see what it...

Get a fuel pressure gauge on it and see what it does when this stumbling starts happening.

Also, check the catalytic converter. You never know.
Replies: 7
Views: 230
Posted By Krewat

It has been said here that using 360 pistons will...

It has been said here that using 360 pistons will also get you to a good compression for a 390. Search around, if you're interested.
09-19-2018, 10:08 AM
Replies: 1
Views: 114
Posted By Krewat

The fuel pressure regulator needs to be replaced...

The fuel pressure regulator needs to be replaced }>

The rubber diaphragm has ruptured, and the regulator is leaking internally.
09-18-2018, 07:19 AM
Replies: 2
Views: 225
Posted By Krewat

Go to the dealer and have them run an OASIS...

Go to the dealer and have them run an OASIS report. If the TSB was done, the service will show up on the report.
Replies: 13
Views: 389
Posted By Krewat

Side note: 360's were "tired" straight from the...

Side note: 360's were "tired" straight from the factory :-X14
Replies: 13
Views: 389
Posted By Krewat

Another question would be: Is the F427...

Another question would be: Is the F427 port-matched to the heads?

A 428 has a lot of stroke to begin with, so low-end torque is gonna be there in spades. Rule of thumb is, smaller intake ports,...
09-15-2018, 09:42 AM
Replies: 6
Views: 261
Posted By Krewat

That strange bunch of codes points to low voltage...

That strange bunch of codes points to low voltage and/or a bad alternator because they are all unrelated. Clear the codes, and see if they show up again. Also, try a different scanner. Got a volt...
09-14-2018, 05:27 PM
Replies: 7
Views: 252
Posted By Krewat

Another thing to check, do the headlights flicker...

Another thing to check, do the headlights flicker at idle?

Just curious. A bad diode in the alternator has been known to drive the electronics nuts.
09-14-2018, 09:40 AM
Replies: 7
Views: 252
Posted By Krewat

Long post? Nope, just lots of good info :-X22 ...

Long post? Nope, just lots of good info :-X22

The one thing I see missing is where you take your laser temp gauge and use it on the side of the road while the temp gauge is pegged }>

It's odd...
09-14-2018, 09:32 AM
Replies: 6
Views: 270
Posted By Krewat

Nice stuff - need pictures of/after the install ;)

Nice stuff - need pictures of/after the install ;)
09-12-2018, 09:04 PM
Replies: 21
Views: 2,239
Posted By Krewat

Tread carefully. You know who you are.

Tread carefully. You know who you are.
09-12-2018, 07:48 AM
Replies: 6
Views: 327
Posted By Krewat

Can't mix and match heads and block between 2 and...

Can't mix and match heads and block between 2 and 3-valve motors... pistons are different.
09-12-2018, 07:46 AM
Replies: 166
Views: 34,382
Posted By Krewat

If you read this thread, you'll find that the...

If you read this thread, you'll find that the most likely cause of the issue was lack of oiling during extending idling because of a bad seal at the timing chain tensioner. That truck might be coming...
Showing results 1 to 15 of 342
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.