Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: wdfp
Showing results 1 to 15 of 500
Search took 0.47 seconds.
Replies: 7
Views: 489
Posted By wdfp

It can save a lot of problems if you also run a...

It can save a lot of problems if you also run a ground wire thru the plug so it does not have to ground thru the trailer hitch which makes it intermittent at best. With an iffy ground electricity can...
01-21-2018, 04:35 PM
Replies: 3
Views: 358
Posted By wdfp

Looks like it takes a two stage power valve which...

Looks like it takes a two stage power valve which it seems holley stopped making because they decided a single stage would work ok in them. I saw yours took a 7.0 .5 I think they indicated a 5.5...
01-20-2018, 07:06 AM
Replies: 3
Views: 358
Posted By wdfp

What is the list # on the carb choke tower? Top...

What is the list # on the carb choke tower? Top of the carb front drivers side is where it is located.
Replies: 14
Views: 1,324
Posted By wdfp

All I can tell you is that with 2.25" exhaust on...

All I can tell you is that with 2.25" exhaust on my pickup at about 4,000 rpm the vacuum gauge started rising from zero at wide open throttle so I went with 2.5" duals to the back and it stays at...
10-22-2017, 01:23 AM
Replies: 1
Views: 569
Posted By wdfp

More often than not it is the fuel pump doing...

More often than not it is the fuel pump doing that..
10-22-2017, 01:21 AM
Replies: 1
Views: 412
Posted By wdfp

Could be the main body isn't as flat as it needs...

Could be the main body isn't as flat as it needs to be or the fuel is getting around the power valve somehow. I had a demon the stumped me for a long time and it was the gasket around the PV, it had...
07-08-2017, 01:58 AM
Replies: 5
Views: 422
Posted By wdfp

Also check to make sure when you turn the cap...

Also check to make sure when you turn the cap that the plate moves when you turn it the other direction also. If it does not then the cap was installed incorrectly and you will need to take it off...
Replies: 2
Views: 726
Posted By wdfp

Well there are two at each end of the block on...

Well there are two at each end of the block on each side of the camshaft for the lifter galleys and these you must pay attention to which one comes out of which hole as they are different side to...
04-21-2017, 08:19 AM
Replies: 13
Views: 865
Posted By wdfp

I got mine from them also, fit very well..

I got mine from them also, fit very well..
03-30-2017, 01:20 AM
Replies: 1
Views: 946
Posted By wdfp

You have a ground problem I'm thinking. Check the...

You have a ground problem I'm thinking. Check the grounds at each light, sometimes it is the socket and some where the wire connects to the body. I had to replace some of mine and I got them from...
03-30-2017, 01:03 AM
Replies: 4
Views: 296
Posted By wdfp

I did it and had to change a couple wire...

I did it and had to change a couple wire locations in the curved plug on the lower column, can't remember which ones but somewhere here there is a write up about it. As for the NSS I went to a floor...
Replies: 1
Views: 472
Posted By wdfp

it will bolt up to the automatic trans with no...

it will bolt up to the automatic trans with no problems, standard is a little different story but will still bolt up.. motor mounts are not the same but you have everything you need with the donor...
03-05-2017, 09:20 AM
Replies: 3
Views: 531
Posted By wdfp

might have a line that is leaking when in the off...

might have a line that is leaking when in the off position or the control vale itself, only way to find out is to get back there and check it out. Or a diaphragm that holds things closed.. Or the...
02-27-2017, 12:14 PM
Replies: 10
Views: 1,209
Posted By wdfp

Yes, where you have all the parts with the other...

Yes, where you have all the parts with the other vehicle it should be fine. I did a swap from a 460 auto to a 390 4 spd and everything bolted right on. Had to change the bracket under the dash that...
Replies: 5
Views: 2,353
Posted By wdfp

When I first got my 77 pickup the trans would...

When I first got my 77 pickup the trans would shift to second at 5,000 rpm which surprised me . It is a factory 460 2wd.. Maybe the trans had been worked on but I don't know..
Showing results 1 to 15 of 500
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.