Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: mwsF250
Showing results 1 to 15 of 498
Search took 0.35 seconds.
11-09-2012, 05:43 PM
Replies: 11
Views: 996
Posted By mwsF250

Go forth and enjoy! This note tells me you are...

Go forth and enjoy! This note tells me you are WELL qualified to make some good (and very safe) decisions!
11-09-2012, 05:35 PM
Replies: 15
Views: 2,425
Posted By mwsF250

I would be very surprised if the concession...

I would be very surprised if the concession trailer AND the van on a car hauler would weigh less than 4540 kg....

Depending on the details, this could be a monster and easily cross over into the...
11-09-2012, 05:21 PM
Replies: 11
Views: 996
Posted By mwsF250

Looking forward to hear if anyone has any factual...

Looking forward to hear if anyone has any factual reasons...

As an engineer, I can say that if I was an engineer for one of these trucks, I would request a note like that be placed in all new...
08-03-2012, 07:22 PM
Replies: 37
Views: 2,448
Posted By mwsF250

If you're towing heavy, the FM 70 or BB50 are...

If you're towing heavy, the FM 70 or BB50 are still bearable in the racket and drone department... And that's about it. After that, it boils down to what you can stand.
Straight pipes? WHAT? ...
08-03-2012, 07:07 PM
Replies: 16
Views: 1,567
Posted By mwsF250

I think about things like this a lot! Some of...

I think about things like this a lot! Some of the grades out here go on for freaking forever!

First off, is it really a lack of power, or just that you don't like the RPM?
IE, are you...
08-02-2012, 06:10 PM
Replies: 4
Views: 555
Posted By mwsF250

Not self returning to center? The three most...

Not self returning to center?
The three most common causes (in order of likelihood) are:
1) Inadequate caster. Did the alignment shop actually measure and record the caster angles? What were...
08-02-2012, 05:33 PM
Replies: 4
Views: 1,421
Posted By mwsF250

Not entirely positive, but I was under the...

Not entirely positive, but I was under the impression all modular 8's and 10's shared bell housing bolt patterns.
My '06 V10 short block (from a 3V engine at that....) bolted right up to the...
08-02-2012, 05:23 PM
Replies: 7
Views: 523
Posted By mwsF250

Depending on where patches are, a thick rubber...

Depending on where patches are, a thick rubber bed liner may be a good solution.
my $.02: Those are my preference by a long shot anyway, as I really dislike the greased snot traction of plastic...
07-30-2012, 02:31 PM
Replies: 4
Views: 6,003
Posted By mwsF250

I suspect "pretty to look at" was not very high...

I suspect "pretty to look at" was not very high up on the mission requirement list...
07-30-2012, 02:26 PM
Replies: 23
Views: 1,308
Posted By mwsF250

I looked at all those, and selected Goodyear...

I looked at all those, and selected Goodyear DuraTracs.
Very, very pleased I did.
The load capacity is rather impressive, if that matters to you.

If snow/ice performance matter to you, I believe...
07-30-2012, 02:15 PM
Replies: 27
Views: 3,448
Posted By mwsF250

Good Pacesetters? Never heard of such a...

Good Pacesetters? Never heard of such a thing....
Every one I've fussed with either didn't fit right, rusted out, warped, leaked, etc etc etc. Bottom line, gone within 50K miles.

Valuable...
07-30-2012, 02:09 PM
Replies: 7
Views: 5,025
Posted By mwsF250

Everything new? Including orifice tube and...

Everything new? Including orifice tube and drier?

Time to revert to basics - Analyzing pressures and temperatures at various locations of the refrigerant circuit.
07-25-2012, 03:21 PM
Replies: 1
Views: 4,799
Posted By mwsF250

I believe the return is skinny, but not positive....

I believe the return is skinny, but not positive.

I took the easier way out as my old fluid was in pretty decent condition.
Suck the reservoir dry with turkey baster, refill. Drive truck. ...
07-25-2012, 03:14 PM
Replies: 4
Views: 4,599
Posted By mwsF250

More 4Wd = more 4WD parts made = less cost per...

More 4Wd = more 4WD parts made = less cost per part.
07-24-2012, 07:06 PM
Replies: 126
Views: 32,434
Posted By mwsF250

And me? I tow TT behind 4WD truck. Usually with...

And me? I tow TT behind 4WD truck. Usually with quads on top of bed rails and/or motorcycles hanging off front and rear bumpers and inside bed. Aerodynamically messy to say the least. And over...
Showing results 1 to 15 of 498
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.