Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: 95 F150
Showing results 1 to 15 of 499
Search took 0.81 seconds.
Replies: 4
Views: 353
Posted By 95 F150

All I had to swap out was the intake and carb...

All I had to swap out was the intake and carb when I converted from the variable venturi to the 4 barrel setup.
Replies: 5
Views: 857
Posted By 95 F150

Get the FIPK but don't get the throttle body, I...

Get the FIPK but don't get the throttle body, I did and it was a total waste of money no to mention I lost alot of low end power from it. I ended up putting the stock throttle body back on and all is...
Replies: 3
Views: 295
Posted By 95 F150

Not trying to be a know it all but the center...

Not trying to be a know it all but the center intake bolt is a torx t-40. Good luck on the gasket swap and whatever you do dont over tighten the bolts that hold the upper intake to the lower intake...
10-23-2005, 12:10 PM
Replies: 18
Views: 801
Posted By 95 F150

I disconnected the coolant lines to my throttle...

I disconnected the coolant lines to my throttle body and few years ago and can tell you for a fact that the EGR has no coolant passage what so ever. The EGR hooks straight into the upper intake...
Replies: 5
Views: 355
Posted By 95 F150

I guess that's not to bad, I've seen them in...

I guess that's not to bad, I've seen them in Muscle Mustangs & Fast Fords for 209 dollars a set plus shipping. Ford want 125 bucks a piece, dream on Ford.
10-12-2005, 05:35 PM
Replies: 2
Views: 298
Posted By 95 F150

Not sure about everything else but your engine is...

Not sure about everything else but your engine is a 351w.
10-09-2005, 06:21 PM
Replies: 5
Views: 415
Posted By 95 F150

I've had good luck with my Percy's dead soft...

I've had good luck with my Percy's dead soft aluminum header gaskets, they are reusable and wont burn out. I bought them 2 years ago at Autozone for about 40 bucks.
10-09-2005, 12:31 PM
Replies: 2
Views: 717
Posted By 95 F150

Go with the 95, alot less sensors to worry about.

Go with the 95, alot less sensors to worry about.
10-08-2005, 01:14 PM
Replies: 13
Views: 548
Posted By 95 F150

Looks good to me, the tires look fine I wouldn't...

Looks good to me, the tires look fine I wouldn't change a thing.
10-08-2005, 01:08 PM
Replies: 2
Views: 526
Posted By 95 F150

I ran a Diablo in my 5.0 powered truck for about...

I ran a Diablo in my 5.0 powered truck for about a year and to me it didn't do much for power, you can get most of the same results of the chip by bumping your timing to 14* btdc and getting an...
Replies: 6
Views: 463
Posted By 95 F150

I would skip the the chip, throttle body and...

I would skip the the chip, throttle body and injectors for now since you are on a limited budget and you would see minimal gains from those parts.
10-08-2005, 07:34 AM
Replies: 8
Views: 551
Posted By 95 F150

LMC truck has all the parts you mentioned...

LMC truck has all the parts you mentioned available in black. I've ordered from them many times and the quality is OEM or better.
10-04-2005, 08:09 PM
Replies: 9
Views: 1,269
Posted By 95 F150

It's just held on by tape, use a blow dryer or...

It's just held on by tape, use a blow dryer or heat gun and peel it off. I used 3m adhesive remover to get the left over tape off the truck.
Replies: 5
Views: 374
Posted By 95 F150

Has the transmission fluid and filter ever been...

Has the transmission fluid and filter ever been changed, the filter could be dirty not allowing fluid to pass through it causing the trans to slip. This happened on a Mustang we used to have and the...
Showing results 1 to 15 of 499
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.