Ford Truck Enthusiasts Forums - Search Results

Notices
 
Search: Posts Made By: sideout2
Showing results 1 to 15 of 213
Search took 0.83 seconds.
06-30-2009, 05:34 PM
Replies: 3
Views: 300
Posted By sideout2

After a search I found one post. Looks like there...

After a search I found one post. Looks like there is a "breather" or sorts on the front, by the pump.
06-30-2009, 02:41 PM
Replies: 3
Views: 300
Posted By sideout2

96 F150 transmission overheated.

Hi All
Been a while. I have a 96 F150, 6cyl, E4OD. I have 3.08 gears. I picked up a new boat and it was pretty hilly towing it back to the house. While backing it into my covered area. I noticed...
11-29-2005, 12:05 PM
Replies: 2
Views: 195
Posted By sideout2

If the CV joint is in good shape, they can be...

If the CV joint is in good shape, they can be reused to have someone build a new drive shaft. It cost me $150 in Austin, TX to have one made.
11-18-2005, 06:21 PM
Replies: 13
Views: 645
Posted By sideout2

hey all, I have been looking around on the NET...

hey all, I have been looking around on the NET and found some possiblities. Dose anyone know where/is there is a ABV solenoid valve?
11-16-2005, 03:24 PM
Replies: 13
Views: 645
Posted By sideout2

yep, it will idle fine and you can rev it up like...

yep, it will idle fine and you can rev it up like it is supposed to work.

With them connected you can feather the pedal to keep the RPMs up and it will run, kind of like you had to with a leaking...
11-16-2005, 10:15 AM
Replies: 13
Views: 645
Posted By sideout2

The air hookup for the IAC goes to the air tube....

The air hookup for the IAC goes to the air tube. There is an empty box in the middle of it. I have the breather and PCV setup like the 96 had it. The breather is on the right hand side as you are...
11-15-2005, 02:57 PM
Replies: 13
Views: 645
Posted By sideout2

I bought a reman MAF from autozone. I am going to...

I bought a reman MAF from autozone. I am going to check the TPS and IAC tonight. Do you know if the TPS can be adjusted or is tested the same as the SB fords?
11-15-2005, 12:57 PM
Replies: 13
Views: 645
Posted By sideout2

thanks, I pretty much just swapped the long...

thanks, I pretty much just swapped the long block. I am using the 96 comp., MAF, intake and wiring harness. The cam and crankshaft sensors are from the 95. I just left the timing cover on. Wonder if...
11-15-2005, 09:17 AM
Replies: 13
Views: 645
Posted By sideout2

Will only run with air cleaner disconnected from the throttle body.

Hi all. I swapped a 4.6 from a 95 Thunderbird to a 96 Thunderbird. Both came with the 4.6, thought they had a different intake from one another. The 96 has the same intake as the 96 Mustang. Any how...
11-15-2005, 08:21 AM
Replies: 5
Views: 2,515
Posted By sideout2

These are very picky. You have to make sure you...

These are very picky. You have to make sure you get it correct or the valves may hit the pistons. There is a mark on the timeing chain cover for TDC. Line it up, then take it apart. Make sure you get...
11-01-2005, 04:47 PM
Replies: 15
Views: 910
Posted By sideout2

I had the same issue on 90 F150 I6 E4OD. I...

I had the same issue on 90 F150 I6 E4OD. I replaced the MPLS first per a TSB and that did not fix it. It was the TPS after all even though it tested fine. Took me two weeks before I found the...
10-19-2005, 03:55 PM
Replies: 3
Views: 6,478
Posted By sideout2

There is mark on the timeing cover. It says TDC...

There is mark on the timeing cover. It says TDC in little letters. I Think there are three marks on the timeing cover and it is the left most one.
10-18-2005, 09:04 AM
Replies: 6
Views: 545
Posted By sideout2

Thanks All, I took a valve cover off last night...

Thanks All, I took a valve cover off last night and it is getting oil. The oil just seeps out of the lifters. Is this normal? I am going to pull the heads and check it out. I'll let ya'll know.
10-17-2005, 04:06 PM
Replies: 6
Views: 545
Posted By sideout2

On another discussion, how long would it take for...

On another discussion, how long would it take for the head to get fully oiled after the valve adj. have been bled? I have heard maybe a min or so.
10-17-2005, 03:17 PM
Replies: 3
Views: 343
Posted By sideout2

Around that time the E4OD had a Manual position...

Around that time the E4OD had a Manual position lever switch(MPLS) that would tend to get water in it. You can get an updated one from Ford. Though I had an issue like yours and after replacing the...
Showing results 1 to 15 of 213
 


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.