Ford Truck Enthusiasts Forums - Search Results



Showing results 1 to 15 of 101
Search took 0.31 seconds.
Search: Posts Made By: pete497
Forum: 2004 - 2008 F150 06-19-2012, 06:25 PM
Replies: 192
Views: 406,880
Posted By pete497
I'm wondering if you could run the Livernois...

I'm wondering if you could run the Livernois programming without installing the mechanical limit in the phaser and quite the noise.
Forum: 2004 - 2008 F150 05-04-2012, 07:11 PM
Replies: 9
Views: 14,262
Posted By pete497
It's actually worse than that. Usually the studs...

It's actually worse than that. Usually the studs are broken or will break in removal. The bad part is you can't get to them. If you bring it to a shop make sure they know what they're in for.
Forum: 2004 - 2008 F150 03-09-2012, 11:15 AM
Replies: 22
Views: 24,408
Posted By pete497
I figured I would give an update on what I did...

I figured I would give an update on what I did since I am disappointed with the result. I bought MBRP cat back 400 Stainless duals. I am really displeased with the degree they are rusting. Even...
Forum: 2004 - 2008 F150 03-01-2011, 05:22 PM
Replies: 2
Views: 621
Posted By pete497
I replaced mine on my Lariat with an aftermarket...

I replaced mine on my Lariat with an aftermarket one from wheelskins I think.

Its much nicer than stock, but it was a lot of work getting it on. Not hard just time consuming.
Forum: 2004 - 2008 F150 12-16-2010, 05:42 PM
Replies: 88
Views: 204,399
Posted By pete497
Well I guess I'll relate my story. I bought my...

Well I guess I'll relate my story. I bought my 05 used in 2007 with about 50,000 miles on it. When I was looking at it I was going to walk away because I heard this funny noise that I couldn't...
Forum: 2004 - 2008 F150 12-13-2010, 12:56 PM
Replies: 294
Views: 853,716
Posted By pete497
This is something I came across on the other f150...

This is something I came across on the other f150 forum

ImageShack® - Online Photo and Video Hosting (http://img4.imageshack.us/i/dealerr.jpg)
Forum: 2004 - 2008 F150 12-12-2010, 08:16 AM
Replies: 42
Views: 20,351
Posted By pete497
Take every COP off remove the boots and clean the...

Take every COP off remove the boots and clean the springs out with carb cleaner. Then take sand paper and scuff up the inside of the spring. Put some di-electric grease on the boots where they slip...
Forum: 2004 - 2008 F150 12-10-2010, 06:41 PM
Replies: 9
Views: 7,334
Posted By pete497
It's not multi piece until you try to remove it.

It's not multi piece until you try to remove it.
Forum: 2004 - 2008 F150 12-08-2010, 08:33 PM
Replies: 42
Views: 20,351
Posted By pete497
One thing you should do is reset the PCM. Just...

One thing you should do is reset the PCM. Just disconnect the negative battery cable and let it sit for like 20 minutes or something. Reconnect it and take it out. If it doesn't happen I think...
Forum: 2004 - 2008 F150 12-08-2010, 07:36 PM
Replies: 42
Views: 20,351
Posted By pete497
What modifications do you have on your truck. I...

What modifications do you have on your truck. I was able to watch the video but I really can't tell what's going on.
Forum: 2004 - 2008 F150 12-08-2010, 03:07 PM
Replies: 42
Views: 20,351
Posted By pete497
If the fuel is not burning completely it also...

If the fuel is not burning completely it also means there is more oxygen in the exhaust stream than should be. The O2 sensor should pick that up as a lean condition sensing the higher O2. If the...
Forum: 2004 - 2008 F150 12-06-2010, 03:09 PM
Replies: 13
Views: 7,939
Posted By pete497
Ford revised the studs at some point but it's not...

Ford revised the studs at some point but it's not a safety issue so they would never recall it. There is a guy who did a real good write up about his experience. I know you can find a link to his...
Forum: 2004 - 2008 F150 12-06-2010, 10:25 AM
Replies: 13
Views: 7,939
Posted By pete497
Usually its the passenger side and you will...

Usually its the passenger side and you will probably need a new manifold. When you start calling around make sure to find out if they've worked on one before. If they don't know about the broken...
Forum: 2004 - 2008 F150 12-06-2010, 10:17 AM
Replies: 22
Views: 24,408
Posted By pete497
Does anyone know if the stock exhaust can be...

Does anyone know if the stock exhaust can be removed without cutting and without a lift?
Forum: 2004 - 2008 F150 12-05-2010, 06:04 PM
Replies: 42
Views: 20,351
Posted By pete497
The misfiring happens because the exhaust isn't...

The misfiring happens because the exhaust isn't scavenging. I think the lean code would have to be the o2 sensor. I bet the dealer wouldn't even test drive it for $90. I'd rather go to the muffler...
Showing results 1 to 15 of 101

 
Forum Jump

All times are GMT -5. The time now is 01:26 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.