Ford Truck Enthusiasts Forums - Search Results



Showing results 1 to 15 of 482
Search took 0.23 seconds.
Search: Posts Made By: JWA
Forum: Electrical Systems/Wiring 02-19-2018, 06:02 AM
Replies: 13
Views: 260
Posted By JWA
Definitely a wire color and tracer issue, age...

Definitely a wire color and tracer issue, age itself being the bigger factor rather than exposure to sunlight or other elements. These wires are pretty much totally covered buried behind trim panels...
Forum: Electrical Systems/Wiring 02-18-2018, 01:20 PM
Replies: 13
Views: 260
Posted By JWA
Just a quick update----its taken me since Jan 6th...

Just a quick update----its taken me since Jan 6th to start running this problem down once again.

As it turns out the wire in C3136 Pin 9 is black with a red tracer---when calling for reverse I do...
Forum: 2014+ Transit 01-29-2018, 06:43 AM
Replies: 49
Views: 6,337
Posted By JWA
YoGeorge I'm well and fine, to the limits that's...

YoGeorge I'm well and fine, to the limits that's possible anyway. :)

Hope you and yours are good or better as well! :-X22
Forum: 2014+ Transit 01-28-2018, 12:35 PM
Replies: 49
Views: 6,337
Posted By JWA
There comes a vehicle with a "love it or hate it"...

There comes a vehicle with a "love it or hate it" vibe, the full-sized Transit seeming to be heading that way. I've acquired another E-Series, this time a '05 extended body Club Wagon variant which...
Forum: Electrical Systems/Wiring 01-06-2018, 04:26 PM
Replies: 13
Views: 260
Posted By JWA
Actually I was using my DMM's continuity tone...

Actually I was using my DMM's continuity tone function, testing to see if circuit #140 was ground only. The threshold for a tone is 200 ohms or less so that explains why I was showing continuity to...
Forum: Electrical Systems/Wiring 01-06-2018, 03:10 PM
Replies: 13
Views: 260
Posted By JWA
Your information agrees with my printed EVTM 100%...

Your information agrees with my printed EVTM 100% and thanks for posting those .PDF's here.

I'll split the connector apart and look for voltages relative to the DTR sensor's location.

Thanks!...
Forum: Electrical Systems/Wiring 01-06-2018, 12:48 PM
Replies: 13
Views: 260
Posted By JWA
What I'm not getting is any voltage at my point...

What I'm not getting is any voltage at my point of tapping or splicing. The lamps in the tail light housings do come on, go off as I'm shifting in and out of reverse. This is with key on in "run"...
Forum: Electrical Systems/Wiring 01-06-2018, 08:55 AM
Replies: 13
Views: 260
Posted By JWA
Thanks Franklin1---appreciate the reply! :-X22 ...

Thanks Franklin1---appreciate the reply! :-X22



I don't have the TorqueShift trans, have tried tapping into the black/pink wire but in-line, not after the bulb in the tail light housing.


...
Forum: Electrical Systems/Wiring 01-05-2018, 03:25 PM
Replies: 13
Views: 260
Posted By JWA
Reversing Lamp Circuit Trigger?

2005 E250, 5.4 gas engine................looking for a signal out of the Transmission Range Selector as it runs to the actual tail light housing to illuminate the reversing lamps. By my reckoning...
Forum: Cooling, Heating, Ventilation & A/C 12-28-2017, 06:58 AM
Replies: 0
Views: 187
Posted By JWA
Blower Motor Assy CFM?

Are spec's for blower motor assemblies published anywhere easily accessed?

I have a 2005 E350 with factory air including the auxiliary (rear) heat &A/C unit, want to re-route the air flow so...
Forum: Clutch, Transmission, Differential, Axle & Transfer Case 12-11-2017, 05:39 AM
Replies: 0
Views: 215
Posted By JWA
Axle Vent Tube?

Need to raise the height of my axle vent tube fitting maybe 1/8" to accommodate a U-bolt added to install a Hellwig rear sway bar. Are these generic threads or super specific to the exact axle...
Forum: Cooling, Heating, Ventilation & A/C 12-09-2017, 07:54 AM
Replies: 3
Views: 560
Posted By JWA
Time for a small update---found what seems to be...

Time for a small update---found what seems to be an excellent and purpose-built kit for this very use, eliminating rear factory A/C.

The company known as Auto Cooling Solutions have these parts...
Forum: 1968-2013 Full Size Vans 12-05-2017, 09:41 PM
Replies: 504
Views: 242,042
Posted By JWA
Not sure how heavy you're talking about my me...

Not sure how heavy you're talking about my me 2003 E250 extended body weighs in at just about 7,800 pounds, the type spec'd for that chassis worked fine, I didn't mind the extra money for the control...
Forum: 1968-2013 Full Size Vans 12-05-2017, 11:56 AM
Replies: 504
Views: 242,042
Posted By JWA
Some of them NASCAR boys used to "string a car"...

Some of them NASCAR boys used to "string a car" sumpin' fierce. :) Of course all the hi-tek fancy computer-based alignment systems today are based on those same principles of comparing this to...
Forum: Modular V10 (6.8l) 12-04-2017, 03:53 PM
Replies: 52
Views: 63,292
Posted By JWA
:) :) Good gravy I swear there ain't two...

:) :)

Good gravy I swear there ain't two people who agree what torque should be used. :D

Every time this comes up for discussion I'm reminded of this thread: ...
Showing results 1 to 15 of 482

 
Forum Jump

All times are GMT -5. The time now is 08:09 AM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.