Ford Truck Enthusiasts Forums - Search Results



Showing results 1 to 15 of 213
Search took 0.61 seconds.
Search: Posts Made By: sideout2
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-30-2009, 06:34 PM
Replies: 3
Views: 298
Posted By sideout2
After a search I found one post. Looks like there...

After a search I found one post. Looks like there is a "breather" or sorts on the front, by the pump.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 06-30-2009, 03:41 PM
Replies: 3
Views: 298
Posted By sideout2
96 F150 transmission overheated.

Hi All
Been a while. I have a 96 F150, 6cyl, E4OD. I have 3.08 gears. I picked up a new boat and it was pretty hilly towing it back to the house. While backing it into my covered area. I noticed...
Forum: 1978 - 1996 Big Bronco 11-29-2005, 01:05 PM
Replies: 2
Views: 191
Posted By sideout2
If the CV joint is in good shape, they can be...

If the CV joint is in good shape, they can be reused to have someone build a new drive shaft. It cost me $150 in Austin, TX to have one made.
Forum: Modular V8 (4.6L, 5.4L) 11-18-2005, 07:21 PM
Replies: 13
Views: 639
Posted By sideout2
hey all, I have been looking around on the NET...

hey all, I have been looking around on the NET and found some possiblities. Dose anyone know where/is there is a ABV solenoid valve?
Forum: Modular V8 (4.6L, 5.4L) 11-16-2005, 04:24 PM
Replies: 13
Views: 639
Posted By sideout2
yep, it will idle fine and you can rev it up like...

yep, it will idle fine and you can rev it up like it is supposed to work.

With them connected you can feather the pedal to keep the RPMs up and it will run, kind of like you had to with a leaking...
Forum: Modular V8 (4.6L, 5.4L) 11-16-2005, 11:15 AM
Replies: 13
Views: 639
Posted By sideout2
The air hookup for the IAC goes to the air tube....

The air hookup for the IAC goes to the air tube. There is an empty box in the middle of it. I have the breather and PCV setup like the 96 had it. The breather is on the right hand side as you are...
Forum: Modular V8 (4.6L, 5.4L) 11-15-2005, 03:57 PM
Replies: 13
Views: 639
Posted By sideout2
I bought a reman MAF from autozone. I am going to...

I bought a reman MAF from autozone. I am going to check the TPS and IAC tonight. Do you know if the TPS can be adjusted or is tested the same as the SB fords?
Forum: Modular V8 (4.6L, 5.4L) 11-15-2005, 01:57 PM
Replies: 13
Views: 639
Posted By sideout2
thanks, I pretty much just swapped the long...

thanks, I pretty much just swapped the long block. I am using the 96 comp., MAF, intake and wiring harness. The cam and crankshaft sensors are from the 95. I just left the timing cover on. Wonder if...
Forum: Modular V8 (4.6L, 5.4L) 11-15-2005, 10:17 AM
Replies: 13
Views: 639
Posted By sideout2
Will only run with air cleaner disconnected from the throttle body.

Hi all. I swapped a 4.6 from a 95 Thunderbird to a 96 Thunderbird. Both came with the 4.6, thought they had a different intake from one another. The 96 has the same intake as the 96 Mustang. Any how...
Forum: Modular V8 (4.6L, 5.4L) 11-15-2005, 09:21 AM
Replies: 5
Views: 2,456
Posted By sideout2
These are very picky. You have to make sure you...

These are very picky. You have to make sure you get it correct or the valves may hit the pistons. There is a mark on the timeing chain cover for TDC. Line it up, then take it apart. Make sure you get...
Forum: 1978 - 1996 Big Bronco 11-01-2005, 05:47 PM
Replies: 15
Views: 901
Posted By sideout2
I had the same issue on 90 F150 I6 E4OD. I...

I had the same issue on 90 F150 I6 E4OD. I replaced the MPLS first per a TSB and that did not fix it. It was the TPS after all even though it tested fine. Took me two weeks before I found the...
Forum: Modular V8 (4.6L, 5.4L) 10-19-2005, 04:55 PM
Replies: 3
Views: 5,870
Posted By sideout2
There is mark on the timeing cover. It says TDC...

There is mark on the timeing cover. It says TDC in little letters. I Think there are three marks on the timeing cover and it is the left most one.
Forum: Modular V8 (4.6L, 5.4L) 10-18-2005, 10:04 AM
Replies: 6
Views: 542
Posted By sideout2
Thanks All, I took a valve cover off last night...

Thanks All, I took a valve cover off last night and it is getting oil. The oil just seeps out of the lifters. Is this normal? I am going to pull the heads and check it out. I'll let ya'll know.
Forum: Modular V8 (4.6L, 5.4L) 10-17-2005, 05:06 PM
Replies: 6
Views: 542
Posted By sideout2
On another discussion, how long would it take for...

On another discussion, how long would it take for the head to get fully oiled after the valve adj. have been bled? I have heard maybe a min or so.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 10-17-2005, 04:17 PM
Replies: 3
Views: 341
Posted By sideout2
Around that time the E4OD had a Manual position...

Around that time the E4OD had a Manual position lever switch(MPLS) that would tend to get water in it. You can get an updated one from Ford. Though I had an issue like yours and after replacing the...
Showing results 1 to 15 of 213

 
Forum Jump

All times are GMT -5. The time now is 06:53 AM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.