Ford Truck Enthusiasts Forums - Search Results



Showing results 1 to 15 of 500
Search took 0.35 seconds.
Search: Posts Made By: danr1
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 08-25-2016, 01:34 PM
Replies: 6
Views: 414
Posted By danr1
Both 5.8L I did a little bronco few years...

Both 5.8L

I did a little bronco few years back, all I had to add in was two circuits, solenoids from the EEC main harness down to the trans connector. Everything else was basically plug and play....
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 08-25-2016, 11:48 AM
Replies: 6
Views: 414
Posted By danr1
I already pulled the under hood harness, gonna...

I already pulled the under hood harness, gonna need it and the computer, based on past experiences they don't tend to put in those circuits that are not going to be needed.


I was hashing it over...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 08-25-2016, 11:00 AM
Replies: 6
Views: 414
Posted By danr1
ZF to E4OD (94 auto to 97 manual)

Hey guys swapping manual for auto....I understand everyone tends to go the other way but question on wiring a moment if anyone happens to know/has done the same before.

How much of the wiring is...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-14-2016, 02:47 PM
Replies: 27
Views: 921
Posted By danr1
I tested couple vehicles before making my post...

I tested couple vehicles before making my post rather than go off memory.

I tested my 351 along with a Pontiac with a V6.

The V8 and the V6 run great and about instantly fire right up, they...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-14-2016, 01:29 PM
Replies: 27
Views: 921
Posted By danr1
I realize that, it wasn't clear until his post #7...

I realize that, it wasn't clear until his post #7 exactly what he was trying to do and "not getting an amperage reading on two different meters" reason for a couple posts/comments that had been made...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-14-2016, 01:01 PM
Replies: 38
Views: 1,761
Posted By danr1
Did you look into the vaccum line port? that is...

Did you look into the vaccum line port? that is where the adjustment screw would be if it has one. I do not recall if all of them did or not, I do not believe the stock modulators where but just too...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-14-2016, 12:33 PM
Replies: 27
Views: 921
Posted By danr1
You'd need a clamp meter like this one, ...

You'd need a clamp meter like this one,

https://cimg7.ibsrv.net/gimg/www.ford-trucks.com-vbulletin/1120x2000/80-img_20160314_121958100_d4d548b9c1c5f028030e2e16fbe0e46e88f55313.jpg


to measure...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-14-2016, 07:47 AM
Replies: 7
Views: 774
Posted By danr1
Biggest problem you have is starting out in 3rd...

Biggest problem you have is starting out in 3rd gear.

KOEO self test codes can not be "cleared", the problem must be corrected or they will cause problems when driven/they will remain until...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-12-2016, 08:13 AM
Replies: 6
Views: 591
Posted By danr1
I suspect he's talking about quench height. ...

I suspect he's talking about quench height.

What Is The Ideal Quench Height? - Hot Rod Magazine (http://www.hotrod.com/how-to/engine/1311-ideal-quench-height/)
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-10-2016, 10:15 PM
Replies: 108
Views: 3,342
Posted By danr1
You can buy plugs at the auto parts to plug those...

You can buy plugs at the auto parts to plug those ports.

Nope, don't use pipe plugs as they would damage the master cylinder.
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-10-2016, 07:56 PM
Replies: 108
Views: 3,342
Posted By danr1
Computer says it doesn't open via the EVP, you...

Computer says it doesn't open via the EVP, you could prove that if you felt it necessary.

If it's not functioning due to a computer problem then really no reason to block it off.

Remaining...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-10-2016, 07:12 PM
Replies: 108
Views: 3,342
Posted By danr1
If I did the test I'd pull the computer out of...

If I did the test I'd pull the computer out of its pocket then plug it in under the hood with its cover off where I could get to it easy.

Test using section of wire with a small alligator clip at...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-10-2016, 06:32 PM
Replies: 108
Views: 3,342
Posted By danr1
No not marked on the inside but easy to figure...

No not marked on the inside but easy to figure out which one is for pin 33 on the inside just by looking.

Red arrows point to the bars connecting each pin on the connector side down to the...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-10-2016, 06:14 PM
Replies: 108
Views: 3,342
Posted By danr1
As previously stated blocking off the egr passage...

As previously stated blocking off the egr passage won't hurt a thing, no one here would intentionally tell you to do something that would or might cause damage.

The egr valve on my 94 had been...
Forum: 1987 - 1996 F150 & Larger F-Series Trucks 03-10-2016, 05:52 PM
Replies: 40
Views: 2,054
Posted By danr1
If you take a black one from any 94-96 (97HD)...

If you take a black one from any 94-96 (97HD) model it would be correct for your truck.

Temp sending unit is located right here behind the thermostat housing where the top radiator hose connects...
Showing results 1 to 15 of 500

 
Forum Jump

All times are GMT -5. The time now is 07:56 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.