Ford Truck Enthusiasts Forums - Search Results



Showing results 1 to 15 of 460
Search took 0.25 seconds.
Search: Posts Made By: piratius
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 03-18-2017, 04:05 PM
Replies: 355
Views: 46,788
Posted By piratius
Even as a temporary "wire it in to make sure that...

Even as a temporary "wire it in to make sure that everything is working as intended" it might not be a bad check before you try to find a PSOM that hasn't been flashed a handful of times already -...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 03-15-2017, 04:20 PM
Replies: 355
Views: 46,788
Posted By piratius
Is there any way you could use the australian...

Is there any way you could use the australian speedometer corrector in "Square wave" mode between the stock PSOM and the EEC-IV Computer?

That way it inputs the square wave and outputs a slower...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 03-08-2017, 11:15 AM
Replies: 355
Views: 46,788
Posted By piratius
That's good to know - on some systems they...

That's good to know - on some systems they multi-task ground wires, so not having one hooked up can cause weird stuff to happen.

If you didn't worry about the lockup in the converter, you could...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 03-04-2017, 10:05 AM
Replies: 355
Views: 46,788
Posted By piratius
Check out Ford Paint Code "54" from 1987. It's...

Check out Ford Paint Code "54" from 1987. It's listed as "Bright Caramel Metallic". I only know it exists because I tried to repaint my '87 Tempo, and somehow got #54 instead of #51. Either way,...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 03-01-2017, 12:19 PM
Replies: 355
Views: 46,788
Posted By piratius
The internet seems to agree that the E4OD should...

The internet seems to agree that the E4OD should be seeing about 8000ppm from the speed sensor. If speedometer output is up at 19,000, then you need a 57.9% reduction in the PPM to get you down to...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 02-28-2017, 06:31 PM
Replies: 355
Views: 46,788
Posted By piratius
The E4OD is electronically controlled - does it...

The E4OD is electronically controlled - does it have the proper computer driving it? Make sure that the module is getting power, is properly grounded, and that the Speed sensor and Manual Lever...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 02-23-2017, 11:09 AM
Replies: 355
Views: 46,788
Posted By piratius
That's awesome! It helps that the motors...

That's awesome!

It helps that the motors that came in both were very similar, and I'm glad you've got it running! Sounds great too!
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 12-29-2016, 11:28 AM
Replies: 355
Views: 46,788
Posted By piratius
Good catch on that Injector line! I had a...

Good catch on that Injector line!

I had a twin-turbo v6 Mustang years ago, and when I put the bigger injectors into it, somehow one of the rails got tweaked upwards slightly (which leads me to...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 11-17-2016, 04:23 PM
Replies: 355
Views: 46,788
Posted By piratius
Out of curiousity, I went online to look. ...

Out of curiousity, I went online to look.

you can search on eBay for the following:

1) 3/4" 36 spline to 3/4" DD shaft
2) 3/4" DD shaft
3) 3/4" DD shaft to Ford triangle

And you'll find...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 09-28-2016, 03:05 PM
Replies: 355
Views: 46,788
Posted By piratius
That's looking fabulous! Does the new...

That's looking fabulous!

Does the new K-member just bolt up to the frame directly with new holes drilled in the frame? (i.e., are the frame rails the same width as the spacing on the other K...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 09-13-2016, 11:31 AM
Replies: 355
Views: 46,788
Posted By piratius
It's looking great! I think you keep...

It's looking great!

I think you keep updating the thread for a few reasons - first off, it's a great way to remember what you've done, with both pictures and text! Secondly, as long as the photo...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 08-19-2016, 11:10 AM
Replies: 355
Views: 46,788
Posted By piratius
Interesting change of directions! Question...

Interesting change of directions!

Question about the frame cut - is there an advantage to slotting the frame and having the "C" sections go through one another (last picture, where you're...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 05-20-2016, 03:54 PM
Replies: 59
Views: 38,513
Posted By piratius
According to the Wiring Diagram Here:...

According to the Wiring Diagram Here: http://fordification.net/tech/images/wiring/wiring_79master_1of9.jpg

Directly coming from the top of the starter motor relay (found in block C-4), wire #37 is...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 05-18-2016, 03:54 PM
Replies: 59
Views: 38,513
Posted By piratius
So it was the fusible link with the Black/Yellow...

So it was the fusible link with the Black/Yellow wire :p If you had checked for resistance between both ends of that wire (the connector that was loose, and anywhere else after the fusible link) you...
Forum: 1973 - 1979 F-100 & Larger F-Series Trucks 03-25-2016, 12:16 PM
Replies: 355
Views: 46,788
Posted By piratius
That might work, but depending on how quickly it...

That might work, but depending on how quickly it updates, and what kind of resolution it offers, you might get a bit of lag between where you start moving and when it updates.

Interesting idea...
Showing results 1 to 15 of 460

 
Forum Jump

All times are GMT -5. The time now is 07:45 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.