Ford Truck Enthusiasts Forums - Search Results



Showing results 1 to 15 of 118
Search took 0.49 seconds.
Search: Posts Made By: Pagemaker
Forum: Aerostar 08-31-2006, 10:37 PM
Replies: 3
Views: 1,386
Posted By Pagemaker
I didn't think about scrolling through all the...

I didn't think about scrolling through all the pages, I just kept doing all the searches I could think of and couldn't find anything.
Forum: Aerostar 08-31-2006, 01:39 PM
Replies: 3
Views: 1,386
Posted By Pagemaker
fixed it

Well I got it started.
The neg. battery clamp was corroded and not very tight. It looked fine from the outside but the inside was corroded. Cleaned and tightened and it started right up. Check...
Forum: Aerostar 08-31-2006, 12:46 PM
Replies: 3
Views: 1,386
Posted By Pagemaker
Check Engine Light Stays On With Key Off

I have a '94 Aerostar 3.0 Automatic
This morning it wouldn't start and the check engine light was on even with the key turned off. The dome lights were very dim. Something apparently stayed on all...
Forum: Aerostar 06-14-2005, 07:03 PM
Replies: 6
Views: 383
Posted By Pagemaker
Yes, I've replaced it on mine. You will have to...

Yes, I've replaced it on mine.
You will have to open the door and then you will see clearly how to remove it with 2 bolts (they may be a star type bit, I can't remember for sure) but its not very...
Forum: Aerostar 06-12-2005, 09:00 AM
Replies: 11
Views: 521
Posted By Pagemaker
Excellent, I'll have to remember that. Yes, the...

Excellent, I'll have to remember that.
Yes, the door has been slammed more times than I can count.
Forum: Aerostar 06-11-2005, 09:33 AM
Replies: 11
Views: 521
Posted By Pagemaker
Yeah, I replaced that already, and adjusted the...

Yeah, I replaced that already, and adjusted the door every way I could think of. But it still did it on rough roads. I think my door may be warped.
Forum: Aerostar 06-10-2005, 03:54 PM
Replies: 11
Views: 521
Posted By Pagemaker
sliding door "clicking"

It really got on my nerves before I wired those two contacts together when I was on a trip, so I took some black tape and placed it over the top contact.
The light stayed on the rest of the way...
Forum: Aerostar 06-10-2005, 12:22 PM
Replies: 6
Views: 383
Posted By Pagemaker
Sounds to me like the latch at the rear of the...

Sounds to me like the latch at the rear of the door...
Forum: Aerostar 06-10-2005, 12:18 PM
Replies: 11
Views: 521
Posted By Pagemaker
Yeah, that's what I did

Yeah, that's what I did
Forum: Aerostar 06-09-2005, 12:31 PM
Replies: 6
Views: 383
Posted By Pagemaker
Inside Sliding Door Handle?

Are there any aftermarket replacement handles for the inside sliding door handle? I have used everyone from every junkyard in my area, and still after a while my kids manage to strip the factory...
Forum: Aerostar 06-09-2005, 12:25 PM
Replies: 11
Views: 521
Posted By Pagemaker
Clicking From Sliding Door

I have adjusted the sliding door until I'm blue in the face and still on rough roads and high speeds the relay under my dash would click on and off (iritating the crap out of me) due to the door...
Forum: Aerostar 05-20-2005, 09:52 PM
Replies: 5
Views: 9,031
Posted By Pagemaker
Noticed a couple of problems

I finished replacing the Caliper, both Rotors, Inner/outer bearings (both sides) and New brakes. I did notice that the rotors where on the wrong sides, no doubt causing heat to build up. I also...
Forum: Aerostar 05-20-2005, 11:34 AM
Replies: 5
Views: 9,031
Posted By Pagemaker
AutoZone Brakes Caught On Fire!

I had to rescue my wife yesterday, she was stranded in our Aerostar due to our AutoZone "Lifetime warranty" brakes catching on fire. Luckily there was a woman close by that was able to hose them down...
Forum: Aerostar 05-20-2005, 11:06 AM
Replies: 8
Views: 635
Posted By Pagemaker
I'm going to start carrying a fire extinguisher...

I'm going to start carrying a fire extinguisher just as a precaution.
My wife heated up our AutoZone "lifetime" brakes to the point of catching fire.
Luckily they were close to a very nice ladies...
Forum: Aerostar 01-06-2005, 10:34 PM
Replies: 17
Views: 784
Posted By Pagemaker
Sounds Like the Best Way To Do It

I have to admit that sounds like a better way to do it. I wish I had thought of that!
Showing results 1 to 15 of 118

 
Forum Jump

All times are GMT -5. The time now is 03:06 AM.