good machine shops central Jersey to the shore?
 

May be pulling my 5.0 soon and boring it or getting a 5.8L and doing the same.

Anyone have good machine shop recommendations for the standard rebuild stuff, magnaflux, boring, honing, etc? Would prefer Monmouth, Burlington, Ocean county but will go further to get a good job.

IDM in Mayetta. Rt.9, just south of Rt. 72
Mayetta is between Manahawkin and Tuckerton.

IDM Cylinder Heads
870 US Hwy No 9
Stafford Township
609-978-6411

Thanks Kevin!

there is also Ryan industrial on RT#79 in Matawan. Chris Ryan, the owner does some really good work.

732-566-9538
tell him Tom Cohan sent you.

I was going to same the same thing. Eddie is a good guy over there. I used him all the time for my drag car. He does good work. I haven't had anyting done in about 3 years but that's the only one I can think of in the area you are asking. Otherwise I would point you to New York or Philly.