Welcome the latest member
 

Everyone give a warm welcome to: Old_Crow :-jammin

Hope to see you at the march meet..

Welcome, come on in and join the fun:-X05

Cool, thanks for the welcome. Hope this darn snow is gone by March.

I'm in the process of a 302/C6 conversion on my '61 F-100. I'm down to the wiring, exhaust, shifter and driveshaft/rear end to finish it up.
Not sure what I'm gonna do about the driveshaft, my donor truck is an '82 so the rear end housing is too wide to just swap, and the original rear end is about shot.
Then, of course, there's all the stuff I'm gonna fix "while I'm in there". ;)

Been there, Done that. :-X18 Good Luck :)

Welcome to the chapter old_crow. I had to "google" Fox just to figure out where it is....pretty country up your way.

Welcome to the group. Good luck on the project. I am working on an 87 full size Bronco so I completely understand the while I'm in there stuff.

Finally got around to adding the new guys to the member list. Apologies for the delay.

Welcome to the club!!