6.4L Fuel Pressure Gauge install
 

I have a 2009 f250 6.4l that I am trying to install a fuel pressure gauge on. I bought the truck with Glowshift pillar gauges in it already. The boost and egt gauge were hooked up and working already but the fuel pressure gauge did not have a sensor to plug into. The gauge colors work andthe sensor wire ran into the engine bay already. I called glowshift and they do not offer a vehicle specific sensor for the 6.4l. I am trying to find out where I need to install the fittings for the sensor to get a good reading to tell if the filters are starting to get dirty and what fittings and sensor I need to make this gauge work. I will also be installing a FASS fuel system this week when it gets delivered. Truck has been deleted with an H&S XRT programmer with and CAI.

At the Schrader valve on fuel cooler you should have 35-55 Kpa (5-8 psi). As far as plumbing it in, I haven’t done one so I can’t say for certain what’s the easiest.