Bench seat question
 

This guy has a bench seat from a 61 f100... Would this fit my 64 f250? Just seems like a pretty good deal.

http://phoenix.craigslist.org/nph/pts/3535131454.html

The foam looks shot.

91, It should fit, but it is a little pricey in my book. More than I would give for it.


John :-X06

Seats are the same thru the mid 80s as i recall...I have a later model one in mine, but I cant tilt the back forward unless both doors are open as its a little wider and hits the armrests. Original 61-66...and I would venture to guess through '72 didnt have a seatback latch like the 73 up trucks do...

- cs65

Wow, thanks for the replies. I contacted him and he said he could put new foam and a new cover on my seat for $200. Seem like a good deal?

Re covering your seat for 200 bucks is a good deal assuming he uses quality foam and vinyl. IMHO!

Good to know. I was considering buying a carpet or vinyl kit from macs but I might just go to a shop and have them lay some carpet. Any ideas on what that should cost?