IDI Dyno Day
 

Just thought I would post this up, as there has been lots of interest in the past. The first dyno day I didn't make it to, had a pretty good turn out, and then the second time I dyno'd was very short notice and I didn't really put it out.

As of right now we are looking at August 18th. This will be at Dynomite Diesel in Monroe, WA. He has a dynojet with a crank sensor.

Cost last time was $50/per person, and he let us do tinkering in between runs, as well as run our own trucks.

I'll be there

Yup il be there to

If I aint sold the 83, I will turbo it and bring it....

I'm holding you to that :-X04

Bring it NA...we need more comparison! Try to beat my NA run on that dyno....140/286 wheel power

baaahahahaha

LOL can't forget that smoke show...so embarrassing...Psd guys got a good laugh out of it

If i wasnt 200 miles away i would prolly show up just so i could be embarrassed lol.
Rob

That's not bad il be 90mi away that weekend! Come on youl enjoy it!

Need more boost.... 7-8lbs is just not enough.. LOL

We can help with that ;) fuel, air, and timing

Pump is up 2 flats right now, i had my old motor timed at 10° and injection pump was up a bit higher and i have a cone filter to help with the more air part, but havent got the timing meter back to get this one exact yet. The old motor use to hit 10lbs unloaded.
I just need some custom up pipes and put my HX40 on it LOL

no need to be embarrassed. This is an IDI dyno day with nothing crazy showing up. The more people we get, the more fun it will be.

I will be bringing the timing meter with me for people wanting to get their trucks timed, and if there is any interest shown, I could make sure there were some turbo-cal pumps there.

If you're in, we can use this thread for that purpose, to create a roster.

The old pig is running decent, still doesn't make crap for boost - maybe 6 WOT. I need to max the fuel screw and see what it does then besides explode.

If I can make it, I'll bring a cam:-jammin