Think my clutch is slipping with my ZF5
 

When I did my M5OD to ZF5 swap. I didn't replace the clutch. I had to take the clutch disc and plate off to install the transmission the way I did it. I aligned it back with an alignment tool. Well it did good for awhile and today when I was going home from work I notice when I gave gas hard my RPMS would rev up high but I wouldn't go no where. It would do this sometimes on me and sometimes it won't.


Any ideas if you think it is the clutch slipping? Hate to have to pull back the tranny again!

Did you bleed/service the master cylinder/clutch slave cylinder when you did the swap?

Yes, 3 times.