Billet Grill
 

I am thinking of getting the T-Rex Bar Billet Grill for my 2010 F150 STX.
Has anyone gotten one of these and how easy are they to install. I says that I have to cut out the existing grill but when I looked a it, it looks like it is held in by clips and screws.

I installed the T-Rex grill in my 2010 FX4. You do have to cut the old grill out so the t-rex will fit, and yes it is held in with clips and screws but you can not see them once installed. The t-rex fits in the grill like and oem part. Just be sure to take your time removing the grill from the hood. There are clips along the top of the grill that attatch it to the hood be very carful and take you time removing it or you will break the clips holding the grill to the hood. Here are a few pictures of my truck with the grill and the process of removing the plasctic grill. Hope this helps.
http://i796.photobucket.com/albums/y...0F150/poij.jpg
http://i796.photobucket.com/albums/y...20F150/004.jpg
http://i796.photobucket.com/albums/y...F150/007-1.jpg
http://i796.photobucket.com/albums/y...20F150/005.jpg

Thank you for the information, The grill does look better then I thought it would. The open grill will give me better air flow out here in Las Vegas when the the temps hit the triple digits.

I have replace the OEM grill with the T-Rex billit grill and as far as I am concerned it is a 100% inprovement in the looks of the truck. Thanks for all the assistance that I received from the members on this site.