Titan Tank Installation - VIDEO
 

Here you go fellas, in HD if you have the bandwidth:

YouTube - 2011 Ford Super Duty Titan Fuel Tank Installation

GREAT VIDEO!

But :-RTFM

http://i195.photobucket.com/albums/z...376/Diff-1.jpg

I knew it would happen some time. Next someone is going to start telling me to clean up my garage. ;)

Haha, maybe. But mine's worse! :p

I only said that because I've heard that it's possible to stress the pumpkin and cause minor leaks by jacking it from the center like that. Never seen it done, just have heard stories...:-X22

Epic, that was awesome.....THANK YOU.....wonder if the lwb tank will be a similar install.....should be, it's only another 16 gals.

Great job.

You are truly amazing!! Thanks.

I just gotta save a grand for the Tank....LOL

Still amazing!!!

Shane

Epic very cool! You wanna help me install mine? Did the ground clearance decrease any? How about a skid plate?

Honestly, I've always wondered about that. Obviously Ford wouldn't have spent the time putting ink to paper if it wasn't important. Guess it's just a mentality that it won't happen to me. Maybe the rubber in the jack distributes the load a little bit?

I'm sure it will be similar. This is really easy, truly only a double Diet Dew job.

Come on up to Utah! Bet we could do it in 70 minutes! Didn't think to measure before and after but it hangs down a good 3 - 4 inches or so. Skid plate is on it. It's just another layer of plastic really. Wraps up and around the tank about 3 inches.

I've never seen Utah,looks like really cool there. Wonder if we could modify the stock metal skid to fit?

It would be a major mod. You'd have to extend the vertical members that attach to the truck and probably bend them to fit around the larger tank anyway. And it's too short, it would only cover the back 2/3rds of the new tank. Ricatic and I were musing over the possibility of making our own. A nice sheet of 1/8th inch aluminum custom cut and bent to fit wouldn't be that big of a deal.

Could you post a side shot pic of the truck when you get the chance to get an idea on how low it hangs down... Your gonna enjoy that new tank for sure seeing that we got rooked on the small tank in the 1st place huh?

Great video!

Nice work!!!

I gave you your just kudo's over at rvnet...Great job...I have not had a chance to work on the skid plate design. I am stuck in Indy for the next ten days...work just gets in the way...

Once again, great job Epic. I tried to rep you but it wouldn't let me :(