Loaded Clyde up with my wife and my two dogs and picked up a few bales of bermuda for the farm. The new dizzy and wires seem to be helping a little. I need to get off my butt and put in my new spark plugs, though. That should help immensely. As for the fuel leak, it doesn't seem to be an issue anymore, although I'm probably always going to take a knee and check every time I get out. I guess that's the beauty of an old truck. Paranoia keeps your attention on performance.

took the body lift off the cab of the truck. Gonna start working on pulling the bed off soon. But I don't think I'll be putting it back on. Gonna work on a flatbed for it.


http://saoffroad.com/forums/picture....ictureid=10312
http://saoffroad.com/forums/picture....ictureid=10313
http://saoffroad.com/forums/picture....ictureid=10314

Stuff for "The Buffalo"
 

Added a (free) almost new Drake Welding, Inc. Lumber rack to the truck. It looks great with no bent hooks!

Why? Because it was a $1,200 USD rack for free? I dunno . . . It's hard to pass up a deal like that.

Ray

pictures,Ray. Pictures!

I got 80% tint put on my door windows. Now they match my tinted rear window :)

o_O
 

I'll be going to my favorite photo location today. Last night it was dark by the time I was near a camera.

And no, I do not do cellphone shots with my Motorola W385 because 640x480 @ some lousy quality doesn't cut it in my book. :D

Ray

Got the tach and the new switch for the cargo light mounted today. I'll finish the wiring this week. Had to clean the MAF sensor to get the check engine light to go out.

great looking truck, where did you get those beadlocks?:-X22

I was trying to figure out how to post the pics but got frustrated and gave up. some help?

I guess you're talkin' to me....



They're from Creative Engineering Offroad. Custom cut, one-of-a-kind, that I paid extra for, so I'd be the only person to have 'em.

Creative Engineering Offroad Fabrications - Home

if they're huge, size em down to about 800x600

upload them to photobucket, or a site like it, then whenever you want to post a pic, just cut and paste the IMG code from photobucket to your post and it'll be there

Covered it in grass again mowing the lawn, so I gave it a bath when I was done with the lawn.

Coming Up!
 

Okay, greyghost85, here they are. Had to use an alternate spot for photographic work. Not my fave but it did just fine.

http://www.raystankewitz.com/img/buffalo_1197.jpg

http://www.raystankewitz.com/img/buffalo_1201.jpg

There ya go! One very sturdy rack for the total cost of $6.04 USD (the hardware).

Ray

I took my boards off today, and a piece of the exhaust.
before
http://i656.photobucket.com/albums/u...0/100_1038.jpg

after
http://i656.photobucket.com/albums/u...0/100_1079.jpg
http://i656.photobucket.com/albums/u...0/100_1078.jpg
http://i656.photobucket.com/albums/u...0/100_1077.jpg

OR do what i do: if the image is on a website of any sort, such as facebook or pretty much anywhere, right click on it, go to "view image" and copy and paste the URL from there inside of [IMG][/IMG] and it will show up. example: [IMG]URL[/IMG]