Good afternoon Ken, Dick, John, Bud, Tim and everyone
Hope your Sunday is going good.. Slacking is the thing to do on this cold windy day |
It's still on the cold side here too, don't know about the wind as I haven't been out yet.
|
Howdy again John
You don't have to go out to see if it's windy.. Just listen for the rattling windows...LOL |
Originally Posted by donjamer
(Post 15200687)
Good afternoon Ken, Dick, John, Bud, Tim and everyone
Hope your Sunday is going good.. Slacking is the thing to do on this cold windy day |
Howdy Dick..
My day is going good.. Slacking at it's finest |
Originally Posted by donjamer
(Post 15200730)
Howdy Dick..
My day is going good.. Slacking at it's finest |
http://i108.photobucket.com/albums/n...psfjphxqc1.jpg
https://i108.photobucket.com/albums/...psvefozskp.jpg It fell out... good thing for wheel wells.. :) was actually lighter than i was expecting.. and my transmission jack was being annoying too... it kept bleeding down its its still got air that needs bled out or its low on hydraulic oil... either way was being aggravating.. inside the bell housings a mess.. but cant see for sure where it was coming out at... did notice the input shafts a little loose... i can move it up and down left and right.. spins pretty free.. which im sure its supposed to spin.. but dont think it should move directionally like that... |
Originally Posted by Sparky83
(Post 15201105)
http://i108.photobucket.com/albums/n...psfjphxqc1.jpg
https://i108.photobucket.com/albums/...psvefozskp.jpg It fell out... good thing for wheel wells.. :) was actually lighter than i was expecting.. and my transmission jack was being annoying too... it kept bleeding down its its still got air that needs bled out or its low on hydraulic oil... either way was being aggravating.. inside the bell housings a mess.. but cant see for sure where it was coming out at... did notice the input shafts a little loose... i can move it up and down left and right.. spins pretty free.. which im sure its supposed to spin.. but dont think it should move directionally like that... |
yup... now the question is my next move...
|
Originally Posted by Sparky83
(Post 15201181)
yup... now the question is my next move...
|
Originally Posted by PSD DickW
(Post 15201260)
You gotta fix the tyranny and put it back in!..LOL
|
Good evening Shawn
Looks like you been busy |
Originally Posted by Sparky83
(Post 15201541)
true.. but how... dont have the tools... so either got to find out if the dealer will let me take it in and drop just the tranny off for rebuild.. or find a specialty shop to do it.
|
just a little don......
|
Originally Posted by PSD DickW
(Post 15201582)
It would probably be better to have the dealer or a specialty shop rebuild it rather than doing it yourself!
|
All times are GMT -5. The time now is 05:59 PM. |
© 2024 MH Sub I, LLC dba Internet Brands