I'm very sorry guys. I had some setbacks in my personal life. I'm back on here and I've emailed all the people that wanted the GB if they still want to participate.

Let me know if you do by responding to my email or sending me a PM.

Again - I'm very sorry to have dropped the ball on this.

No hard feelings, we all get run over once in a while :-drink

Hope things go better for you! :-X22

So is this going to happen again? I replied to the email I got with a question and no responce.

Went ahead and ordered from amazon.

I'm still in. Let me know what the policy is on non-cellphone mount products, as I put in an order for other stuff as well.

Kuda Mount
 

Since this is in the tech thread, here is another version that I like from Kuda:

https://cimg5.ibsrv.net/gimg/www.for...4461f448bc.jpg

It's leather covered...all you do is take out the stereo and pull the top dash loose, it slips in with a clip that holds the front on tight, then you slide it into place so the area above the stereo grips the front. No drilling required.

https://cimg6.ibsrv.net/gimg/www.for...2006dae3f7.jpg

If you have an aftermarket stereo, you can run your wiring through the 'pocket' and behind the dash for a clean install. I later 'flipped' the stereo mount kit to get the pocket on the top:

https://cimg7.ibsrv.net/gimg/www.for...3ebebdfd6c.jpg

You can get 'double' plates to mount more than one device on it...I have it holding my cell phone, my Garmin GPS, and the head unit to my VHF/UHF:

https://cimg8.ibsrv.net/gimg/www.for...f8622849c2.jpg

https://cimg4.ibsrv.net/gimg/www.for...c019c02fd9.jpg

iOttie easy one touch 2
 

I've had good luck with this brand mount. No issue sticking and holding on the uneven Excursion dash.

Photo of the box. https://www.amazon.com/iOttie-Holder.../dp/B00JRGOKQ8