Ford Truck Enthusiasts Forums - View Profile: Tricon

Go Back  Ford Truck Enthusiasts Forums > Members
Reload this Page >

Tricon's Profile

Notices
Tricon has a good reputation on FTE.Tricon has a good reputation on FTE.Tricon has a good reputation on FTE.

Tricon Tricon is offline

Postmaster

Visitor Messages

Showing Visitor Messages 1 to 10 of 11
  1. JGORD
    02-15-2019 04:07 PM - permalink
    I had looked far and wide for how to enable the indicator light in my cluster after installing fogs and couldn't figure out what FFV meant in the forscan spreadsheet. Someone on here said it should stand for Flex Fuel Vehicle, so I'm pretty sure it is in the IPC code 720-01-02 option 1 that I need.

    What I wanted to ask you though was about the upgraded cluster you installed. I think I might have it all figured out, but I had quoted and asked you in another thread if the MyKey thing auto generated or if I would have to do anything to get my truck to start after installing the new cluster, which it looks like you answered already so thanks for that. I have a guy in NY that said he can do mileage and hours that I've used before. I just got done paying for a cluster that only had 13k miles for $350 from car-part. Couldn't stomach the $750+ people wanted on Ebay. Any tips and pointers on the install, including what to do with forscan, would be greatly appreciated.
  2. JGORD
    02-14-2019 08:41 PM - permalink
    Looks like you have experience in upgrades I want to end up doing. Hope to be able to pick your brain a bit.
  3. jimson
    02-06-2019 06:59 AM - permalink
    Thanks for the feedback.
  4. jimson
    01-26-2019 08:00 AM - permalink
    "Just get a 2 channel amp and some good front component speakers. They will play loud and clear. Rears are for fill if anything at all, money is wasted back there. Only thing you might want to add is a sub down the road. Front components and an amp can be around $250 and will give you the biggest bang for your buck. Dont do what some guys here have done and buy 3 way 6x9's or coaxial speaker for the front. You'll ruin the soundstage more than anything else. Replace the tweeter and mid with something reputable and you'll be rocking."

    Question, I installed JL Audio 3 ways and disabled the factory tweeters and rear speakers. It sounds good to me but I'm no expert, am I missing something? Thx.
  5. markusarealuis
    12-02-2018 07:26 PM - permalink
    I want to do a console swap for my jump seat in my 2019 SD can you send me a link where you found a console....? Thank you!!
  6. swacer
    11-11-2018 10:48 PM - permalink
    Tricon, Are you running Fuel Mavericks? If so, what offset? Really like the look. Thanks
  7. bheath26
    06-25-2018 02:32 PM - permalink
    I think I pretty much want to copy your truck. I see you put air bags on, was that just for towing, was that after the carli lift? I didn't know you could do airbags and a lift. I don't think I am the best at searching on this thing so I was wondering if you had posted your compressor build yet? Did you get the Carli Add-a-packs or is that why you went with airbags? Is the airbags a better option for towing/hauling and ride? Thanks for all the info.
  8. bheath26
    06-22-2018 01:19 PM - permalink
    Hi, I was wondering how you are liking your lift set up? Did you have to trim anything for 35s? All carli with fox shocks correct? Any plans for 2.5s in the rear? How is the ride compared to a 150 now? I drove both stock, and got the 250, I didn't notice too much difference in ride on washboard roads, big bumps definitley stiffer but, I'd really like to keep the box from jumping around on bumpy roads. 2017 f250 SCREW SB platinum
  9. LethalLimited
    03-25-2018 07:07 AM - permalink
    Seen a post you made in the Forscan thread about enabling low level inputs from the factory head unit.
    I have a 2017 F-150 Limited with the Sony factory setup. I was wondering if you can pinpoint me on how to get low-level signal without the need for a Line Driver.

    I removed the stock subwoofer.
    My current setup is a rockford Line driver tapped into the harness that connects to the Sony AMP getting signal from the Drivers front speaker to signal my Class D amp.

    I got a custom woofer box where I can now add 4 6.5x6.5's and want to keep the factory Sony amp to power the stock speakers.
    I'll be adding an additional 4-channel amp for the 4 6.5's

    Basically I want to have one amp to get low level signal from the oem plug that went to the stock woofer and I can use the line driver to the other amp.
  10. Vanquish Auto
    07-10-2017 05:20 PM - permalink
    ok but I have to tell you the fog lights are a big deal on this kit, they are really bright and create a great cutoff too! I can do them for $75 so you can take some pictures, help me out here thanks

About Me

  • About Tricon
    Location
    SoCal
    Interests
    Moto, moto, moto...
    2 Letter State/Province (use "--" for outside USA/
    CA
    Country of Residence
    US
    Make
    Ford
    Model
    F-250
    Year
    2017
    Current Mileage
    0 - 24,999
    Miles per year
    Rather not say
    Gender
    Male
  • Signature
    2017 F250 CrewCab 4x4 FX4 6.7L Diesel General Grabber 35x12.5R18
    Carli 2.5" Lift + FOX Factory Edition 2.5 + 2.0 with CD adjusters

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 11:31 PM
  • Join Date: 04-11-2017
  • Referrals: 0

Friends

Showing Friends 1 to 1 of 1

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.