Ford Truck Enthusiasts Forums - View Profile: ap67et10

Notices
ap67et10 is starting off with a positive reputation.

ap67et10 ap67et10 is offline

Senior User

About Me

  • About ap67et10
    2 Letter State/Province (use "--" for outside USA/
    ca
    Country of Residence
    US
    Make
    Ford
    Model
    F-100
    Year
    1964
    Current Mileage
    Rather not say
    Miles per year
    10,000 - 14,999
    Gender
    Male

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 03-22-2017 01:42 AM
  • Join Date: 04-12-2014
  • Referrals: 0

Visitor Messages

Showing Visitor Messages 1 to 5 of 5
  1. 01-20-2018 06:01 AM - permalink
    Hey Andrew, seen your thread about making a stand alone ecm and tcm wiring harness. I'm wondering if you would build me one, swapping a 51 ford body onto a 99 f150 4x4.
    The old 99 has been a great truck for me but I'm ready to put the Lightning blower on it and all that goes with it.
    If you could email me at [email protected]
    Side note, you ever look at doing a stand alone harness for the 99-2001 7.3 powerstoke? If you do let me know cuz I want to put one in a old 50's style flat bed.
    Thanks
    Jeremy
  2. F100 '64
    11-22-2017 08:35 AM - permalink
    I am just starting my CV swap, what year car did the rear end come out of? What year and car did the rear wheels come from? I'm using a 2005 CV and right now I think the only wheels that are going to have the correct back spacing are the P71 steel wheels...

    Pat
  3. 03-24-2017 11:57 AM - permalink
    I will be installing CV suspension and 4.6 2v and 4r75w trans swap this summer. I also won't be running the stock PCM. Did you ever build the wiring setups you mentioned previously? Do you have any pointers or direction you can send me?

    Thanks,
    Paul
    [email protected]
  4. 07-11-2016 10:23 AM - permalink
    Good luck with the swap, I'll be following along. If you get to a point where you have lots of issues I can set you up with an aftermarket system that works very well with the EDIS ignition setups. It'd be a pretty easy install, but more costly for sure.



    Saw you state this on a thread I was reading....I will be doing a 4.6 swap from a 96 tbird and would love some info on a setup for wiring....do you sell them?.
    thanks
    Steve
  5. LINCON3537
    01-15-2015 11:08 PM - permalink
    Interested im the drivers side drip rail, from windshield to door, how much for panel and shipping to Oceanside, ca?
    Please reply to my email address ; [email protected]
    Thanks
    Richard

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.