Ford Truck Enthusiasts Forums - View Profile: Rusty_Bits

Go Back  Ford Truck Enthusiasts Forums > Members
Reload this Page >

Rusty_Bits's Profile

Notices
Rusty_Bits is starting off with a positive reputation.

Rusty_Bits Rusty_Bits is offline

Freshman User

Visitor Messages

Showing Visitor Messages 1 to 8 of 8
  1. V8R
    07-28-2011 07:16 PM - permalink
    V8R
    The truck is getting real close. Hoping for the end of August or mid September. Keeping my fingers crossed.
  2. epp
    12-10-2010 09:35 PM - permalink
    epp
    just walked out and measured for you. Measuring from the bottom of the running board to the ground, it is 5 1/2" in the front and 6 1/8" in the back
  3. V8R
    07-09-2010 12:34 AM - permalink
    V8R
    Rusty,

    Sorry I didn't get back to you. I haven't been on for some time. Just got the chassis back but haven't got the truck on the road. I would like to get it going before the snow flies this year.
  4. woodyf1
    02-04-2010 09:17 AM - permalink
    hey rusty no that box is not original it is made by me in my shop custom thanx for the interest and the complement it is my intention to build a woody truck just like ford would have if they had woody
  5. firstrider
    01-31-2010 05:46 PM - permalink
    Mark , the dia. of the fresh air tube is 3.5 " and the sq. in area of the inlet opening is 11.25 . Hope this helps . Just curious , what are you tring to do with these measurments ?
  6. firstrider
    01-28-2010 06:53 PM - permalink
    Mark . will measure dia. of freah air tube and get back to you . About the sq. in. area of the inlet under the top of the r. front fender will figre that out and send with previous duct info . Give me a few days or post your ph. # for mre and I will call. Later ,Denny
  7. Rusty_Bits
    01-26-2010 11:03 PM - permalink
    Just like to say thanks for the warm welcome to the FTE site and to anyone who has taken the time to look at my photographs. regards
  8. Fomoko1
    01-21-2010 03:54 PM - permalink
    Hi, just a heads up to join your local chapter: Canadian National Chapter - Ford Truck Enthusiasts Forums
    Please fill in the location field in your profile, let`s us know where in Canada you are from.
    I`m from Saskatchewan.

About Me

  • About Rusty_Bits
    Biography
    Senior Designer/Draftsman
    Location
    Vancouver, B.C. Canada
    Interests
    Machining, Old Ford Trucks and Cars
    2 Letter State/Province (use "--" for outside USA/
    BC
    Country of Residence
    CA
    Make
    Ford
    Model
    F-1 through F-8
    Year
    1948
    Current Mileage
    Rather not say
    Miles per year
    Rather not say

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 07-05-2016 03:11 PM
  • Join Date: 03-31-2009
  • Referrals: 0

Contact Us About Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.