Ford Truck Enthusiasts Forums - View Profile: Greg M-47

Greg M-47 is starting off with a positive reputation.

Greg M-47 Greg M-47 is offline

Senior User

About Me

  • About Greg M-47
    Brights Grove,Ont. Canada
    Mercury trucks and old MG's
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    Rather not say
    Miles per year
    Rather not say


Total Posts
Visitor Messages
General Information
  • Last Activity: 11-10-2016 06:48 PM
  • Join Date: 01-01-2009
  • Referrals: 0


Showing Friends 1 to 3 of 3

Visitor Messages

Showing Visitor Messages 1 to 10 of 10
  1. 49m47
    09-04-2018 03:51 PM - permalink
    Greetings and long time since we talked. I hope all is well with you.
    I'm having fuel problems. The gas seems to eat right through the fuel pump diaphragm and check valves. I added seafoam today. First time I've ever tried it. have you had any problems or successes?
  2. 02-03-2016 11:12 AM - permalink
    Greetings Greg,

    Which suppliers would you suggest using on the Canadian side of the border? At the moment I'm looking for seat covers for a '66 F-100


  3. 02-05-2014 09:05 PM - permalink
    Greg awhile past u had said that u recovered some seats with the cartouche cover? My question is about the extra foam padding. I'm building a 48 f1 for my daughter and have to add foam for seat heaters and wanted to know how the 1 inch and 2 inch sizes worked out?
    Thank for any info! Steve
  4. oldmerc
    11-02-2012 07:18 AM - permalink
    That panel at the Vulcan airport is on kijiji in the Edmonton area . Check it out .
  5. 02-27-2012 08:58 AM - permalink
    Yes my front and rear glass were shot out. I got replacement glass from National Parts Depot which is an hour drive from here into Michigan. Haven't installed it yet.
  6. oldmerc
    02-17-2012 06:30 PM - permalink
    Hi Gregg
    Did you have to replace your windshield and if so from where did you source it .

  7. 49'er
    02-14-2012 09:42 PM - permalink
    Hi Greg,
    If you prefer to reach me by e-mail regarding those fenders I'm at [email protected]
  8. oldmerc
    01-30-2012 08:15 AM - permalink
    Hi Gregg
    What shade of Red are you going to use on your stainless trim.

    Allan (oldmerc)
  9. 05-12-2009 05:46 PM - permalink
    Thank you C-700. I found bigflatsrivets to be very helpful.
  10. 04-07-2009 10:40 PM - permalink
    Greg, you need to go to they sell the hot rivets and tools to do the job. I did about 50 in my frame and they are beautful. Bolts look so sissy and short cut. It takes a couple attempts to get it right. I had to re-do my first three and then it just got fun. My rivets are larger then yours so yours will be easier. I had to make a tool for my impact hammer to set the largest rivets. Take a look at the web sight and if that does not answer your queations just PM me again.

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.