Ford Truck Enthusiasts Forums - View Profile: Rossta86

Go Back  Ford Truck Enthusiasts Forums > Members
Reload this Page > Rossta86's Profile
Rossta86 is gaining momentum as a positive member of FTE.

Rossta86 Rossta86 is offline

Senior User

Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. Bls9393
    12-29-2016 10:57 PM - permalink
    Im about to do the same swap as you and have a few questions. What flywheel and clutch did you use on your lm7 swap? When you put the gm vss in your transfer case did you have to re tune for it or did it function just fine. Is it something i need to let my tuner know before sending my ecu in? I could use a more info on this as I finish gatheri g parts and I found your thread very useful. Any help is greatly appreachiated
  2. 79FORDWI
    05-04-2011 02:07 PM - permalink
    hey i saw your repair job on the frame cab mounts and i am lookin to do the same, my only question is making sure the hole is going to line up, do u have any idea on the measurements? say from the outside of the cab mount to the start of the hole? Thanks!
  3. Rossta86
    10-07-2009 06:54 PM - permalink
    I got these from TABCO body parts out of OHIO. They needed to be trimmed down and are not exact replacements, but they worked well. Dennis carpenter has the exact replacements.
  4. RonDzierwa
    10-06-2009 08:22 AM - permalink
    where did you get the cab mount boxes pictured in Ford Truck Enthusiasts Forums - Rossta86's Album: Cab Mounts and Floor Repair - Picture ? I got a '76 F250 that needs both sides, and everywhere I look folks only have the bushings, or the part that welds to the frame. If you could point me to where you got this, i'd be really grateful!


About Me

  • About Rossta86
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    250,000 or more
    Miles per year
    Rather not say


Total Posts
Visitor Messages
General Information
  • Last Activity: 08-15-2017 10:55 PM
  • Join Date: 08-10-2005
  • Referrals: 0