Ford Truck Enthusiasts Forums - View Profile: David85

David85 has a good reputation on FTE.David85 has a good reputation on FTE.

David85 David85 is offline

Post Fiend

Visitor Messages

Showing Visitor Messages 1 to 10 of 59
  1. mcwille117
    01-10-2014 12:32 PM - permalink
    Ok after googling C6 to E4od swap I found two posts that you were apart of and your sig has exactly what i want to do in it so i thought I would ask for some advice. Backround: I searched for motorhomes in my budget with what i need for a long time, came across a 1984 E-350 with the 6.9L international. Now I am very partial to this motor because growing up my parents purchased a 1986 F-350 new that had it and we logged 387K mi on it before my dad scrapped it. STILL RAN when he did. very pissed about it but is off topic. I want to pull the C6 that is in this motorhome and swap in a E4OD with a stand alone controller. What budget would i be looking at for that? would $3,000 cover the swap? I know i need the controller, move the crossmember, and a new driveshaft. could you send me some pictures of the under side of your setup? any links? or helpful hints? if you could please point me in the right direction I would appreciate it greatly.

  2. David85
    04-02-2013 07:28 PM - permalink
    This is the plug I'm running on the diesel ranger: 6625,NGK 6625 Glow Plug

    ngk 6625 y-107

    Its supposed to be a dual coil and takes VERY long to heat up. Plan on 30 seconds or more if it gets cold in your neck of the woods. Even in the summer I give 20 seconds to avoid unsightly sputtering. I didn't bother swapping over the complex fast glow control system from the donor truck, so I've got these ones on a push button. I douby it will work with the factory system that mitsubishi offered on the 4D55T.
  3. alf030
    03-26-2013 03:28 PM - permalink
    I saw on a post through Google that you swapped to Kabota glow plugs in your 2.3 diesel. I was wondering what plugs and and additional parts are needed. My plugs are shot and its my first winter with the truck and haven't found a solution. Thanks, Ryan
  4. JHoffman93
    03-21-2013 09:07 PM - permalink
    Hi David, I have been a supporter in the past and on the 17th I decided to renew my membership. The $19.99 charge has posted on my pay pall account but its not activated yet. How long does this take to show up? Thanks, Jason
  5. David85
    10-17-2012 08:27 PM - permalink
    Jay, the cruise control cable has an adjustment at the injector pump end. Pop it off the throttle linkage and you should see a small black steel clip (try using a magnet to find it since everything else will be black plastic). Pop that off and the outer sleeve will slide off to reveal the notches of the cable casing. That will be your adjustment. Moving the cable casing closer to the throttle arm will REDUCE the maximum power the cruise control can apply (this increases the effective cable length). Moving it away will increase the amount of power (this shortens the effective cable length).
  6. jayro88
    10-16-2012 09:41 AM - permalink
    Hey Dave, I was wondering how you adjusted your cruise to reduce the throttle input? I use the cruise quite a bit in my E250 and think this could help my MPG a bit. I searched and couldn't find an answer. I also didnt see where I could PM you from. Thanks

  7. weezer4117
  8. joe f350
    07-02-2012 12:43 PM - permalink
    joe f350
    party time i need to come up and show u how to party
  9. Rifle
    06-27-2012 02:13 AM - permalink
    What does fficeffice" />
  10. David85
    06-27-2012 02:00 AM - permalink
    College.... and no, its not all parties and drinking - lol (actually there's been none of that)

    I'm finished first year now, but I'm up to my neck catching up with other things. My truck is on the to do list and I hope to get to that in the next couple of weeks.

About Me

  • About David85
    I build stuff
    Campbell River, B.C.
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    250,000 or more
    Miles per year
    Rather not say
  • Signature
    1986 F250HD Ex cab Fresh built up 6.9L diesel, Lariat AC leather seats power everything w/full cluster, sterling rear 3.08LS gears, E4OD trans, ram intake ATS 088 turbo

    1986 F150 Ex cab Lariat rollercam 5.0L on LPG AOD trans 3.55 gears 390 000Ks


Total Posts
Visitor Messages
General Information
  • Last Activity: 07-22-2015 12:25 PM
  • Join Date: 11-10-2003
  • Referrals: 1


Showing Friends 1 to 6 of 6

All times are GMT -5. The time now is 12:34 AM.