Ford Truck Enthusiasts Forums - View Profile: shorod

shorod has a great reputation on FTE.shorod has a great reputation on FTE.shorod has a great reputation on FTE.shorod has a great reputation on FTE.shorod has a great reputation on FTE.

shorod shorod is offline


About Me

  • About shorod
    Cedar Rapids, IA
    Bicycling, R/C Car racing, Consumer electronics repair, automotive repair
    2 Letter State/Province (use "--" for outside USA/
    Country of Residence
    Current Mileage
    0 - 24,999
    Miles per year
    1,000 - 4,999


Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 10:09 PM
  • Join Date: 06-22-2009
  • Referrals: 0


Showing Friends 1 to 9 of 9

Visitor Messages

Showing Visitor Messages 1 to 10 of 94
    12-31-2018 04:54 PM - permalink
    Thx for the info, I got a filler tube for a 1997 & the only difference is the way the gas cap fits, my 1996 is a screw in & the 97 is a turn n lock, cheers
    12-17-2018 09:42 AM - permalink
    Hello Rod, I have a 1996 Explorer 5.0L, I cant find a gas tank filler neck for it, is a 1997 the same, thx Gerry
  3. 08-16-2017 07:41 AM - permalink
    here's photo of the plug
  4. 08-16-2017 07:40 AM - permalink
    my email: [email protected]
    thank you very much
    explorer 1995 4.0 ohv
    I need pin + information like
    pin 32 injector 5
    I need petrol injector signals and rpm signal from this 42pin plug
  5. 04-01-2017 09:46 AM - permalink
    Rod, first time on here. I'm in need of a 04 explorer awd V8 diagram for steering pump. My email is [email protected]. thanks in advance, Todd

    I think I posted a reply on the forum also.
  6. 11-06-2016 09:45 AM - permalink
    Thanks Rod. It's a 1999 Ford explorer XLT 4x4 V6 SOHC. You are welcome to send the sift cable replacement instructions to [email protected]. Look forward to your reply. Thanks! Mike
  7. 11-04-2016 02:02 PM - permalink
    What I have is a engine harness that I need to figure out what goes where.
  8. 10-27-2016 08:15 AM - permalink
    Hi Shorod. Thanks for the offer to help!! I have access to AllData...but the diagrams arent helping at this point. Also no real description of whats there.

    Anything you can provide would be awesome!! Thanks!


    [email protected]
  9. 09-13-2016 11:38 PM - permalink
    I have a question about my 04 EB explorer. Its got the dual climate control. The issue I'm seeing is that with the morning temps outside being cooler now, the wife has had to turn the heat on. In the afternoons on the drive home she is having to use the A/C. The passenger side is blowing cool, but the drivers side vents are noticeably warmer. Its almost as if the blend door for the drivers side is slightly open. I'm not that familiar with the dual climate systems. Done a lot of work on the singles. Replaced many blend doors and heater cores in the F150's but nothing with explorers. Any ideas? I've taken the vacuum line off the control valve going to the heater core and believe it or not the drivers side temp did cool off a little, but its still noticeably warmer than the pass. side. I've not looked at it too much yet due to not having time yet.
  10. 09-08-2016 07:45 PM - permalink
    [email protected], My 93 4.0 exployer is still running poor,no power misses,check engine light comes on and off.It backfires too.I have replaced the exhaust,new plugs, wires, and coil pack.All looked good but I replaced them anyways.Vehicle has no power.Mileage is poor.Vaccum lines look good.I am stumped.

Contact Us - About Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to and affiliated sites.