Ford Truck Enthusiasts Forums - View Profile: subford

subford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud ofsubford has much to be proud of

subford subford is online now

Post Fiend

Visitor Messages

Showing Visitor Messages 1 to 10 of 226
  1. quaddriver
  2. quaddriver
    07-22-2017 12:00 PM - permalink
    howdy, years ago (2009) you posted a pic of the wiring diagram for the TFI remount mount harness needed, someone in full size vans needs it, but the pic is no longer active online...can you repost it or send it? thanks!
  3. benny92lx
    05-14-2017 12:24 PM - permalink
    hey subford, I hate to bug you especially after all the input and help you contribute to this and all the forums you are attributed to. As Domgrossi67 stated, you are a remarkable individual with a whole heck of alot electrical knowledge on these ford pickups. It is an absolute honor to have genuine people such as yourself who help out the automotive community. I have used some of the knowledge you have dropped on other posts, but cant seem to find a chassis wiring diagram anywhere for a 1994 eec-iv 460 f250. I was wondering if you may have any input as to where to find some info? thank you!
  4. cppt19
    04-28-2017 07:49 AM - permalink
    Hello Subford, I was wondering if you could help me out with my electrictcal problem (voltage in run position) that I posted yesterday in the 87-96 forum?
  5. sandymane
    03-09-2017 09:56 PM - permalink
    If you have a chance will you please look at my thread ... I have one clue for my high rough idle. I found a missing vac line on the last page but you may need the whole thing to understand. Hope you can and if not I understand. 87-96 150's
  6. domgrossi67
    12-30-2016 08:59 AM - permalink
    hi subford, first off I would like to thank you for you do on this site. You have helped a lot of people for no compensation and I think we all appreciate it. your threads have helped me before also. thank you. now what I was hoping you could help me with is,,, lol always something huh? I am looking for actual schematics and diagrams for the under dash wiring showing not only what wire goes where but colors. My truck was stolen a while back and its as iff they just ripped all the wires out from under the dash to be jerks, as if stealing the truck wasn't enough. They also took it off road and blew out the rearend. Anyways I need to rewire under the dash and cannot find what I need anywhere. Even subscribed to alldata to see if they have it but no. Any help would be appreciated. Even if you know what to search on here for it thanks in advance
  7. jhutchison40
    12-03-2016 05:56 PM - permalink
    Okay, so I used a jump box to check everything out, and I'm losing 9 volts from pin 37 which powers EEC, injectors, etc. Is there any way I can wire from the battery to fuel pump relay directly? The truck sat for awhile, and I'm wondering if something got in there and chewed up some important wires.
  8. jorenn
    12-02-2016 10:18 PM - permalink
    Subford, After reading about every post you have made about fuel pump issues you seem to be the go to guy. I have a 93 with dual tanks, truck has set for a few years in our farm shop. I am not getting power to the pumps. I removed the rear tank to test pump and I am getting 7 volts to it but as I read that is misleading, when I used a test light it had no power. I then tried testing everything I could find you suggested in other threads. I switched relay with one I tested with the horn to ensure it works. Cleaned grounds at both the radiator support and battery to body. I tested power to the fuse, good there. I next tested power at the inertia switch with a test light, the green/yellow wire was not as bright as the red wire. I then was able to get power to the rear pump when I ground the #6 pin in the test connector. The tank selector seems to be functioning, when I switch to front tank I do not get power to rear. I was hoping you had anymore ideas.

    Thank You
    Josh - Manhattan, KS
  9. jhutchison40
    11-21-2016 05:11 PM - permalink
    Hey Subford,

    I have an '89 F150 with a 5.0, dual tank system, I'm wondering what I need to check because I'm not getting any power to the fuel pump relay. I replaced the front tank and fuel pump as well as the inline pump, but when I turn the key to start it, nothing happens. Could you help me out?
  10. devin.preston
    10-17-2016 03:22 PM - permalink
    Hey I created an account just so I can contact you because I heard you are very intelligent. I have a question about my truck. It's a 1996 ford f150 XLT 4.9 300 L6. I drive around town and my emissions monitors get ready. But once I turn the key off everything gets erased including stored codes and monitor status.

About Me


Total Posts
Visitor Messages
General Information
  • Last Activity: Today 11:01 AM
  • Join Date: 08-26-2005
  • Referrals: 6


Showing Friends 1 to 10 of 42

All times are GMT -5. The time now is 12:02 PM.