Hi Brad
Joined the Club with my 1997 F-250 diesel 4x4 two-tone crew cab. After looking everywhere, I decided to reproduce the two different (upper/lower) paint break body stripes in blue/grey. The stripe widths and configuration is perfect. The blue match is also perfect, the silver is real close but not quite perfect. Are members still looking for replacements for these stripes? (Our small company does Glastron vintage boat replica decals, hence the experience.) Thanks for your insight.

Well thanks for nothing Brad! I'm going yard diving tomorrow hope to find just 1.

New guy here seen a post where you have a few of those seat pans wondering if you could part with one and what kind of price you would need? Thanks Randy

Hi Brad

New to the forum, but read your write up of your how-to on the cab light install (really, actually read it). Did the same exact thing on my last truck.
Long story short, got a different truck in better shape, cab lights from factory were on the truck when i bought it. I bought a new set on the link you provided in the post, installed them and siliconed the stainless hardware into the factory screw clamps.
I cant help but notice that they do not sit flush on the cab, mainly the center 3. I notice that in your post it does the same thing, if you know what I mean. Ever had any water intrusion issues with your cab lights? Are all ford trucks this way? 1990 regular cab factory harness, holes and hardware. Please advise. Thank you.

Hey man were you ever able to get the glass out of the rear doors in your crew cab? If so how? im having the same issue. Thanks!

Brad my name is David I have a 1997 f350 cclb
The goal her is to do coilover axle swap any how my question is do you think the speed sensor in the rear end is plug and play or do i need to use the one out of my old axle
the donor 2008 i also under stand the leaf springs are longer do think i can do 2005-2007 spings on the 2008 axle

thank for you help

Hi sir I’m the one asking about the Enforcer Bumper. Please send me an email or cell phone number to contact you on. Thank you, Matt.

Ok thanks for looking. I'll try to find him there.

Brad, I'm new to this forum. I know this is an older thread but do you have the contact info for the guy that made these brackets? https://www.ford-trucks.com/forums/1...b-steps-2.html
Thanks.
Mike

I check that Full Resto thread often. Saw your Sig line is about a Blue 40-20-40 seat. I was at Ace Pull-a-part on Thursday gone and there were 2 sets waiting for new trucks there. Covers in good shape with no holes. Are you anywhere close to Jax, FL? There is also a place called Rusty Acres in Jax, FL that is Ford, Merc, and Lincoln only. They will sell you a set if they have them and will source them if they don't. Both sites are on the innerwebs....