Conversation Between drptop70ss and schoo
Showing Visitor Messages 1 to 5 of 5
-
Hi dave I'm slowly get the rear of the truck finished working on a trailer hitch and was looking for your install could not find it
If you have a few pic of your install could you post to me some
Thanks roy
-
hi dave I'm looking at a 67' olds 442 diff 61 1/2" axle flange to axle flange 3.54
do you think that is to wide? using a 302ci
-
Thanks dave I'm trying to figure this out
-
Roy,
I think the S10 rear would be too narrow, but it depends.
What you want to use will depend on wheel size and rear suspension setup. I am running leaf springs on the outside of the frame like the original F1 design, so I am using a 1970-1981 camaro / firebird rear. Another rear which is the same width would be a 1968-72 chevelle rear. Original brackets have to be removed and new suspension brackets welded on for either one.
If you are running a 4 link or super wide tires then you may want to mock up the tires and see what you need as far as width, wheel mounting surface to wheel mounting surface.
-
hi dave getting ready to look for a rear end to match upwith the jag ifs would a 2wd s10 chevy work some are using a 4wd s10 just wondering about 2wd
thanks roy