Conversation Between julcan92 and havi
Showing Visitor Messages 1 to 4 of 4
-
post an ad in the classifieds on this website, and ask for a set on the '73-79 forum. Also try Ebay and Craiglist. I don't have an extra set, and haven't been to any junkyards lately to look. But I can keep my eyes peeled, that's all I can offer. Good luck!
-
Yes Havi but if you know of any perches please let me know. I m from Argentina is very difficult to get them, as not to say impossible. If you can get me a pair i will pay for them.
Thank you
-
I assume you're putting the 300 in a '79 F150/Bronco? I used '79 F150 4x4 perches, with '79 motor mounts. Engine block was an '85, but I'm pretty sure the casting stayed the same except for the fuel pump slot when they went EFI.
-
Its old, but do you solve it ??
"ok, it's been a while, but I found a pair of perches, bolted them to the front holes just fine, bought 79 4x4 motor mounts for my 86 300-6 and found out the perches are too close together, or the motor mounts are too wide, or that 86 6cyl is cast different. Any ideas?"
Looking for 300i6 1979 f150 4wd perches, if i know of any..
Thank you