Conversation Between Macrobb and hairyboxnoogle

Um, there is one spring inside. Use a small flat-blade screwdriver to get the spring-clip out, then turn it over and dump the parts out. There should be a round plate with a hole in the center and a cup for the pushrod, then a flat disk about .020 thick, then a piston piece that takes up much of the inside of the lifter. *under* that piston, you have a (weak) spring. And that's it.

You know which thread it was that Anderson was talking about the lifters? Thought it was yours, but just skimmed through it and didnt see it. Getting ready to tear into mine, any springy bits to come flying out? Was just going to pull em apart, throw em in some gas, then just soak em in oil dont you?

I couldn't resist. <_<

Pot meet kettle.... lol

Exactly, theyre just pickin on justin because ill garantee you that IDIot and f250 are always bitchin to the mods, and the mods are sick of it.