Conversation Between patrickke and F250_

ok here are the specs

-inlet is almost 4 1/2 to the tube
-end near the inlet is 6"
-total filter length without including the inlet neck is 9 1/4"
-total filter length including inlet neck is 11"
-the measurement at the end of the filter is 5 1/4"
-and the pipe is 4" (intake tube)

This filter is kinda a cone shape but it is much more gradual than most

I will try and get you all the measurements sometime today or tomorrow

From the picture, it looks like the element is tapered.

Here's a list of the measurements I need.

1. Big end diameter (I assume that is the 5-1/2 inch measurement).
2. Little end diameter
3. Length (you've already given me 9-1/4 inches for this)
4. Outside diameter of the filter tube that attaches to the intake.
5. Does the end of the element have an inverted cone?

Let's go ahead and start using email so I can keep the FTE Admins from getting upset over me doing business over FTE resources.
filtercovers@gmail.com

but the actual measurements i just got were 9 1/4 long by 5 1/2 wide

I don't know the dimensions, but I posted a question for you in the thread, too. I just need to know which of the two Brute Force style elements you're running, and then I need you to take some measurements and some pics of the tape measure on the elements, and I can make a cover for either one.

hey pete do you know the specs for an aem bruteforce filter for a 6.0l bc I was wanting one of your pre filters to fit on it