Conversation Between 2000silverbullet and loansinpa

Hi There,
Been doing my research and so far, your info has been most valuable so I figured I'd reach out and ask. Doing an audio upgrade myself. Already put in the lockpick so was originally going to tap off that like you did. Question: did you keep the original amp plugged in since other wires run to it? If not, did it throw any codes/errors? Did you look at tapping into the harness (by adapter) where it plugs into the amp? or after it? I'm working on a '13 250 with the Sony upgraded *cough cough* system. Factory amp was attached to the sub behind the seat. Thinking since that is where my new amps/sub are it would be nice to put the LQi7 back there too and not run so many wires up front. I'm running all new to the speakers too. Wishful thinking but figured you had the insight.
Thanks much.
Tom