05 F350 6.0 Crank no Start with no Ficm sync
More Turbo
Joined: Jul 2009
Posts: 705
Likes: 12
From: Taxachusetts
I had an intermittent stall and no start problem. Turned out the rust on the block swelled and pushed the cam sensor just enough to cause a no start. Pulled the cam sensor cleaned the block up and had to do it again because I didn't get it clean enough the first time. Put a new sensor in and good to go. My sensor base was deformed from the rust pushing it off that I had to get a new one.
Good luck!
Good luck!
Thread Starter
|
New User
Joined: Aug 2019
Posts: 2
Likes: 0
Bad Cam Sensor
Update got a better scanner and it said I had a bad Cam Sensor. Put a new one in today and she fired right up. I put a new FICM in prior to the cam sensor. The FICM has a 100 hp tune. Holy crap does it roll coal. Before I never seen any black smoke at all. Cant wait to take her down the road. I also put the SRL+ tune in it.
Thread
Thread Starter
Forum
Replies
Last Post
