Hand Grip ?
Thread Starter
|
New User
Joined: Jan 2007
Posts: 4
Likes: 0
Hand Grip ?
Has anyone ever installed a hand grip on the passeger side A pillar ? I have a 97 4WD F250. A couple of my friends have a difficult time getting in my truck. My truck is stock height, no big wheels, tires, or a lift kit. So if anyone has installed a hand grip, like the ones on late model trucks, I would appreciate anyone helping me out....thanks
FTE Chapter Leader
Joined: May 2009
Posts: 8,843
Likes: 27
From: Eastern Ky
I haven't actually did it...But have looked into it...
1) The A-Pillar is actually made weird, and has a weird angle, so a piece of metal will need ti be welded in, to make the angle correct for mounting the handle on...
2) The A-Pillar trim, will need 2 holds cut, to allow the ends of the handle to pass through to the metal area previously welded in for structure, etc...
3) After aligning, cutting the holes (A hole saw attachment would be perfect at this point) and mounting the handle, etc....I'd recommend a couple rubber grommets to fill in the gaps and prevent the handle from putting pressure on the trim panel....
Otherwise....Have at it....
1) The A-Pillar is actually made weird, and has a weird angle, so a piece of metal will need ti be welded in, to make the angle correct for mounting the handle on...
2) The A-Pillar trim, will need 2 holds cut, to allow the ends of the handle to pass through to the metal area previously welded in for structure, etc...
3) After aligning, cutting the holes (A hole saw attachment would be perfect at this point) and mounting the handle, etc....I'd recommend a couple rubber grommets to fill in the gaps and prevent the handle from putting pressure on the trim panel....
Otherwise....Have at it....
The Southernmost Mod
Joined: Dec 2004
Posts: 6,902
Likes: 21
From: Caracas, Venezuela
I don't, but i have seen them installed. If it where me in your place, i would search for a side step, it will be easier to install and they are a great help getting in. The grip would probably require some internal gusseting to ensure the body panel doesn't bend because on the passenger's weight.
FTE Chapter Leader
Joined: May 2009
Posts: 8,843
Likes: 27
From: Eastern Ky
1) The A-Pillar is actually made weird, and has a weird angle, so a piece of metal will need ti be welded in, to make the angle correct for mounting the handle on...
2) The A-Pillar trim, will need 2 holds cut, to allow the ends of the handle to pass through to the metal area previously welded in for structure....
I don't, but i have seen them installed. If it where me in your place, i would search for a side step, it will be easier to install and they are a great help getting in. The grip would probably require some internal gusseting to ensure the body panel doesn't bend because on the passenger's weight.
Thread
Thread Starter
Forum
Replies
Last Post
4x484150
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
15
Dec 25, 2013 10:15 PM
dyingtolive
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
6
Jan 26, 2011 09:14 PM
