Removed Accumulator body on 01 X trans to remove/replace solenoid pack. Despite being very careful not displace the check *****, they are now out of place. There are four (2 each of 2 different sizes).

I have searched the forum thoroughly, but haven't been able to find a diagram detailing their proper locations. Some have recommended using the instructions from a transgo shift kit, but I couldn't find a link to those either.

Please either provide me a diagram or link to another thread with the information. Thanks, Dan

 

This is not for the accumulator valve body, but it has the ***** in it as you described.

You should not have to remove this section of valve body or the accumulator valve body to get the solenoid block off, just remove the 1-10mm and all of the torx bolts to get the block off.

 

Thanks JK080.