IC in, but....
#1
IC in, but....
I finally got that thing installed and the piping all hooked up. Yay, right? Well, not so much. I lost the ferrel for my new boost gauge AND, the batteries are dead! Nuts. I should be able to get the ferrel in town tomorrow, but we've got 40-50 mph winds and now the rain is starting, so I'll think about boosting it on Friday when I've got some time. Once I've got her all up and running, I'll post some pics.
#3
Well, the actual work wasn't too bad. It was all the trying to find the right pieces and getting the piping all fabbed up. I'm still short 3 t-bar clamps, but I should be able to pick them up Friday. There's still one piece I'd like to replace. As for the batteries, it's probably time they were replaced anyway. I got the IC itself form TJ almost 2 years ago. It's been a slow process. Total hours of actual work on the install? Maybe 12-15 ish. Kinda hard to say.
#5
Rider, I got some old piping from Clay. and the final elbow from some old exhaust piping that I had lying around. That's the elbow that I'll be replacing someday. I hear ya about the expensive elbows. Up here the elbows would have been $45, but I got a discount through work. I tried it, but it was way to wide an arch to finish what I needed. It's not the prettiest install, but it 'should' work. Oh, I also got my Bushwacker cutouts on the other day.
#7
Trending Topics
#9
#10
#11
Thread
Thread Starter
Forum
Replies
Last Post
locknload223
1999 - 2003 7.3L Power Stroke Diesel
31
07-21-2009 06:48 AM
Beast12
General NON-Automotive Conversation
25
08-15-2006 06:36 AM
true4.2
General NON-Automotive Conversation
52
09-22-2005 11:23 AM
skuteman
Fuel Injection, Carburetion & Fuel System
1
07-17-2004 04:27 PM