Replacement Sheet Metal for 63 Van
#1
Replacement Sheet Metal for 63 Van
I'm new to the forum, and in the process of bringing a 63 8 Door Van back from the pasture. Amazingly, it has refused to rust all these years. It is pretty straight, but I do need a corner panel between the grill and the driver's door, under the headlight. Also need some trim parts. Have found a lot of parts at Macs, but no sheet metal. Anyone know if it is available?
#2
I'm new to the forum, and in the process of bringing a 63 8 Door Van back from the pasture. Amazingly, it has refused to rust all these years. It is pretty straight, but I do need a corner panel between the grill and the driver's door, under the headlight. Also need some trim parts. Have found a lot of parts at Macs, but no sheet metal. Anyone know if it is available?
Are you asking for the front/side corner panel that the parking light fits into? If so...
C1UZ8900271B .. Body Front Corner Panel-Left (Drivers) Side / Obsolete
Fits: 1961/67 Econoline.
GREEN SALES CO. in Cincinnati OH has TWO = 800-543-4959.
No Ford Dealer, no other obsolete parts vendor has any. AFAIK, it's not reproduced.
#3
Thanks Bill, I talked to Mark at Green Sales, and they have one for me. I had found a few in junk yards that were almost as bad as mine. I'm trying to keep filler to a minimum. The old van is going to be sweet...not show quality, I can't afford that, but it will look really good in a walk around. The 240 has been redone. It will soon be ready to start. Most everything is there. Will be looking for some trim, but that can wait till after paint.
Thanks again, Jerry
Thanks again, Jerry
Thread
Thread Starter
Forum
Replies
Last Post
bigbackwindow56
1980 - 1986 Bullnose F100, F150 & Larger F-Series Trucks
1
04-28-2015 03:19 PM
danerisfree
1999 to 2016 Super Duty
0
05-07-2014 08:34 AM