I was backing my truck into my garage to put my new mudflaps on today with the door open. Looking over my shoulder I forgot about the door and backed into the wall of the garage ruining my door and the trim around the garage door. DOH!!! The drivers door is ruined and needs to be replaced, the passenger door needs to be replaced anyways because of rust on the bottom. Luckily it is able to close and I can drive it like this. Here are my questions:
1. How much would new doors cost? Junkyards?

2. How hard is it to convert my truck to power controls? I've owned the truck for a little over a year now and am tired of un-buckling my seat belt to reach across to the passengers door to unlock it already.

3. How hard is to replace a door?

4. What do you think about this paint job: Black on top until the roll on the side panels, then silver in there, then black line-x at the bottom to keep salt and sand under control.

Pics: My Public Shoebox pictures from friends & fun photos on webshots

Thanks,
-Chris

 

I was going to run black herculiner along the bottom of my truck as well...I did some so-so photo-shopping and it looks really good. I have seen a few obs trucks around other forums who have also played w/the bed liners and it looks really sharp.

 

my cab corners are just starting to rust im going to do patch panels and then rather than re-painting the entire truck im going to bed line the bottom, i think it will look good

 

photoshopped pic (not my truck, but close enough)



Some other pictures I have picked up during my research into the project:

 

i think my white extended cab would look good with that. but some colors it wouldnt go well with...

 

I have inquired on color matching my rockers when I get the time for body work and paint on the bed.......it really was not bad price wise for the protection.